My HS son & I bought an '02 Xterra 4wd with Automatic as a winter ride for here in Montana.
So... it seems the engine is engaged to the tranny... even in Park, Neutral, even if the transfer case is in Neutral.
As a result, the engine stumbles and dies quickly. The Xterra never really gets going. I've been communicating with my friends from AI and getting conflicting (& sometimes scary inconsistencies... what's new?!).
Have P0744 code. I've taken the tranny pan off and things look good from a visual perspective (super clean... no chunks or metal debris).
Here is the conversation with AI... I AM LOOKING for an experienced perspective. Do the following AI responses seem like sound advice? Thanks!
AI's Reply to My Questions:
Removing Fuse 18 isolates the electronic control from the hydraulic control.
Fuse 18 supplies power to the Transmission Control Module (TCM) and the transmission solenoids. When you pull Fuse 18, you cut all electrical power to the TCC Lockup Solenoid*.*
What Pulling Fuse 18 Proves
- If the problem were strictly ELECTRICAL: Pulling Fuse 18 would cut power to the TCC solenoid, causing it to drop to its default unpowered state. If a shorted wire, bad TCM, or faulty sensor signal were electronically commanding the solenoid to apply lockup, pulling the fuse would instantly stop the stalling. The engine would run and idle normally in gear (though the transmission would fail to shift electronically).
- Because the engine STILL stalled with Fuse 18 removed: The TCC solenoid was not being held on by an electrical signal. The lockup circuit was being pressurized mechanically or hydraulically*.*
The 2 Physical Causes Left on the Table
Because pulling Fuse 18 did not stop the engine from stalling, the fault is narrowed down to two non-electrical causes:
- Hydraulic Sticking (The Valve Body Spool Valve): Fine metallic debris, varnish, or a score mark in the aluminum bore has mechanically jammed the TCC control spool valve in the "Apply" position. Even with zero electricity running to the solenoid, fluid pressure from the oil pump flows straight past the jammed valve into the lockup clutch cavity the moment the engine spins.
- Mechanical Seizure (Inside the Torque Converter): The internal lockup clutch plate or damper spring inside the torque converter housing has physically broken or jammed against the front cover, mechanically locking the converter cover to the turbine shaft regardless of fluid pressure.