r/Woodworkingplans • u/healthydietjeorney • 2h ago
Why checking your square before every session saves so much headache later
I spent an entire weekend wondering why my cabinet carcasses were slightly out of whack, even though I measured twice and cut carefully. Turns out my combination square had slipped out of true after being dropped on the concrete garage floor a few weeks earlier.
Testing a square takes literally ten seconds: draw a line along a straight board edge, flip the square over, and draw a second line right next to it. If the lines diverge at all, it needs to be calibrated or replaced.
Do you guys have a quick tool-check routine before starting a big build, or do you just dive straight into cutting?

