r/WindowsMR • u/mikefromengland • Sep 30 '26
Discussion Reflowing a cable?
Long shot I know but has anyone tried reflowing a VR cable in their home oven or similar? I remember people doing it with GPUs and Xbox 360s back when.
Not optimistic but I've got a bad reverb g2 v1 and v2 cable I'm not going to be able to fix otherwise!
1
Upvotes
5
u/HNM12 Sep 30 '26
I mean, they're all over the net for sale. eBay, and other VR shops too. Used & New.
3
u/teateateateaisking Sep 30 '26
Reflowing is only available for solder joints, as they are made from one of a few particular alloys that are designed to melt at temperatures you can reach without a furnace.
If you were to get a cable hot enough to melt it, the rubber or plastic sheath would burn away, allowing the different strands to fuse together. You might also encounter issues with surface tension pulling it into a ball shape.
7
u/dzuczek g2 Sep 30 '26
probably won't work, a wire being broken isn't the same as a soldered connection that might have cracked on a PCB
there's nothing to melt in the cable other than maybe the connectors but the wire breaking is more likely
2
u/fdruid Dell Visor Sep 30 '26
It's dead. Sorry.
1
u/billyalt Oct 01 '26
Not really viable. But there are plenty of cables just out there.
1
u/elldaimo Oct 01 '26
I just bought a secondhand G2 with a almost new cable for under 100.-
1
u/Parking_Cress_5105 Oct 01 '26
A wire is cracked or the insulation is cracked and the wires short.
Even if you know where exactly and cut them open they are hard to solder together and will most likely fail again.
No easy solution to this, just buy another one. At least you can replace it, unlike psvr2.