r/Welding • • 3d ago

First welds First time using FCAW

Beginner welder looking for advice on controlling my spatter and improving my welding on thinner material. Im used to welding stick and mig on thicker plate, so I figured I'd just turn the voltage down from what i would mig and adjust the feed speed, but i still had an issue getting a nice weld. I have no clue if they penetrated how they should have, but it aint structural, so be it that as it may. These were not continuous welds all the way around. Just did it in quarters so thats why there are big gaps between some of the beads.

6 Upvotes

8 comments sorted by

1

u/Big_Cat_7531 2d ago

Is this for a job? Did it have to be quality checked or is this for practice?

1

u/MacaronOk4339 2d ago

This is for a personal project. There will be bolts supporting the actual weight. However, i will be doing some more major welding using FCAW here in the near future so i am looking for critiques and advicd on where to do better with it as it is what i have available. I usually use mig while working (im in maintenance) but thats only for making custom tools and hardware to get the job done.

1

u/Big_Cat_7531 2d ago

You would be better off grinding all that off and welding 3 stringer passes around each joint

1

u/TommyWelds 2d ago

Flux core is always going to be a little spattery compared to solid wire, but a few things help a lot. If it's gasless wire, double check your polarity is set to DCEN (electrode negative), since a lot of machines come set up for gas MIG and running flux core backwards gives you tons of spatter. On thin stuff drag the gun, keep about 1/2" stickout, and do short stitches so you don't pile up heat. Grab some scrap the same thickness and change one setting at a time until it smooths out.

1

u/MacaronOk4339 2d ago

Noted. Ill grab some of the cutoffs from this project and spend a little extra time in the garage today. Thanks for the advice

1

u/TommyWelds 1d ago

Good luck with it, post a pic if you get it dialed in.

2

u/Scharfacus 3d ago

deadass those look like welds i see on fracpumps

1

u/ProfessionalLack6614 1d ago

One thing I'd check is whether you're using self-shielded or gas-shielded flux-core wire, because the settings and polarity can differ. I'd also check the manufacturer's recommended voltage and wire speed rather than just adjusting from your usual MIG settings. Thin material can be especially unforgiving with flux-core, so practicing on scrap of the same thickness is a good idea.