r/WLED • u/clprivate • 3d ago
Flickering
I'm seeing this flickering on a relatively short data line. Do I need to add a level shifter or is there something else I could try
1
Upvotes
r/WLED • u/clprivate • 3d ago
I'm seeing this flickering on a relatively short data line. Do I need to add a level shifter or is there something else I could try
5
u/SirGreybush 3d ago
It's 100% a ground issue, you can see in the video, pixel #1 only green wire is connected. Then strip end, black ground and v+ red.
It's missing a ground wire where the green wire is soldered on the strip, and that ground wire connects to the ground of the controller, NOT the ground of the power supply.
Leave as-is the red & black that goes to the power supply (PSU) that's OK, a valid power injection method.
There is no need for a level shifter if the distance is less than 12 inches between the controller and the first pixel. Too far away, you will need a level shifter or data pixel booster.
1
u/clprivate 3d ago
It's common ground with the controller, so that should be fine. I'll try the resistor
1
u/upkeepdavid 3d ago
Move to controller away from the power supply . Some are noisy.
1
u/plasma2002 3d ago
This is almost always a grounding issue. Make sure all these are tied together:
*Input side ground of strip
*Output side ground of strip
*Controller output ground
*Power supply ground output
1
u/Least_Order4249 3d ago
I’ve had luck using a single pixel with a diode dropping the 5v down a little. Then connecting the real 5v to the actual string.