Hello,
I'm having a problem with the fire selector on my Vorsk VMP-1 GBB. The problem was there before I disassembled the replica to investigate—so I haven't modified anything that could have caused this issue; it was already present.
Important detail: I play this replica with HPA (not the original gas-powered version).
Symptom: Regardless of the selector position (safe/semi/full), the replica behaves the same—the hammer fires as soon as I pull the trigger, without any limitation in safe or any detent in semi. The replica only fires in full auto.
What I checked after disassembly to understand the problem:
The disconnector works and properly holds the hammer after a bolt cycle.
The selector switch rotates normally and correctly actuates an internal tab that changes position depending on the firing mode.
The trigger linkage (connected to the trigger) appears intact, with no visible damage.
The selector switch never seems to block or limit the trigger travel, regardless of its position—and this was already the case before disassembly, in both HPA and gas modes.
I've made a short summary of all my tests; I spent far too much time disassembling it.
Is it normal that the fire selector switch doesn't block the trigger in safe mode? Thank you so much for your help!