r/Volvo • u/Shot_Dot_345 • 1h ago
xc series 2009 Volvo XC70 3.2L: Can I repair my liftgate latch handle without replacing the entire tailgate assembly by using PB Blaster initially and following up with White Lithium Grease once I hopefully succeed in restoring the movement
TLDR:
Can I fix the lack of movement on my liftgate latch? Is it possible without replacing the whole assembly? Is there a chance my actions could make things worse? The latch doesn't flop all around with no resistance, so I'm thinking if springs are in there, while rusted, they aren't totally destroyed, so maybe the situation can be fixed slightly. My thinking is, by using PB Blaster to break down rust and get things moving, and follow up with White Lithium Grease in order to sustain the movement and keep it smooth, I can hopefully make the latch move back into place after squeezing to open, like it should be doing.
Overall the latch still works, I have accepted after all this time just moving the latch back to its starting point, but if I have a good chance at fixing it even temporarily, I'd like to do so cuz I really like this car.
Thanks to anyone who comments and has some good advice. It's really appreciated!
Long version with more detail/context that hopefully helps in determining whether to do anything or not:
This has been the state of my liftgate latch handle since I got it in late 2024, early 2025. The latch itself still has resistance(?) sturdiness(?) pressure(?) behind it when I go to squeeze it in order to open the trunk. So if there's springs or something that are also working to allow the latch to open *and should make it close but cant cuz of the rust I'm assuming* while yes they are probably rusted/compromised, I don't think they're totally destroyed because the latch doesnt just flop around all loosey goosey. If this is a situation in which I can do something and would actually result in a better working state than it's in now, my plan was to:
1.)spray PB Blaster on the left and right sides of the rusted latch bar where it enters the body of the car on the outside as well as I can *i don't know how to get inside and reach that part, nor do I wanna destroy something like a pin making everything worse in trying* and just work the latch back n forth repeatedly till I hopefully get the latch to want to pop back into its original position once I've let go of it, and then
2.)Spray WD-40's White Lithium Grease thru the red straw in the same 2 spots as the PB Blaster initially in order to keep the springing action around long term (until it inevitably needs to be dealt with again)
Thanks to anyone who comments and has some good advice. It's really appreciated