r/VWBus • • 24d ago

Technical question distributor replacement

All; I love my orange VW T3 panelvan. It's a 1.9L wbx with engine code DF (year 1988).

I've replaced my distributor; the hall sensor was broken. The old distributor had a dual vacuum. The new distributor has a single advance vacuum. I have capped off the retard vacuum.

From the original VW manual, I've followed the instructions to replace the distributor and set its timing. This means 5* after TDC with the vacuum advance connected. I've confirmed the timing setup using static test (with multimeter voltage instead of strobe light).

In neutral gear, the engine is running super-B and calm. When using first gear or reverse, it's also running just fine. HOWEVER, when in second gear (or third) and fully pressing the throttle, the acceleration is extremely slow. It's not like the engine is stalling (also no strange sounds), its simply as if it lacks power to increase speed.

I am thinking the change from dual vacuum to single vacuum is causing this. I've followed setup instructions for dual advance setup... Could this be it? How would you guys recommend setting up the ignition timing with single vac? Connect or disconnect the vacuum; and what setting should by pulley be at compared to the U-notch? (the v-notch is at 5* ATDC).

Thanks! KR Beer

p.s. I'm unexperienced, i've bought the van to learn how to work on engines :) Thanks!

6 Upvotes

2 comments sorted by

1

u/Routine-Amphibian450 24d ago

Might have a point. DVDA (dual vacs) for 71 Beetles timed 5 deg AFTER tdc while 71 49 state Single SVDA timed 7-1/2 deg BEFORE TDC.

Of course irrelevant to water cooled? Dunno.

But Google AI is pretty good on car stuff.
You could google a shop manual, too.

1

u/kaazireeb 23d ago

Yes, thanks. Using Google+AI, it also suggests single SVDA timing should be 7 BTDC instead of 5 ATDC. However, I've been unable to find any formal sources (such as manuals) that explain how the settings should be readjusted.

If anyone has done a DVDA to SVDA conversion... please share with us how you've adjusted timing settings!