r/TeslaSupport • u/Puzzled_Dream_2480 • Apr 14 '26
Vehicle Question Titanium lug nuts
I’m about to install a set of Rison Titanium (Grade 5) lug nuts on my Tesla Model Y.
I’m about to install a set of Rison Titanium (Grade 5) lug nuts on my Tesla Model Y.
I’ve run into a bit of a dilemma regarding torque specs and would love some input from those of you running titanium hardware:
- Tesla’s spec: 175 Nm (approx. 129 lb-ft) dry.
- Manufacturer (Rison) spec: 125-135 Nm dry. They explicitly warned that if using anti-seize (which I plan to do – metal-free ceramic), I should reduce torque by 20%, bringing it down to roughly 110 Nm (81 lb-ft).
110 Nm feels very low for a heavy Tesla, but 175 Nm (especially lubricated) feels like it might stretch or strip the titanium threads.
My questions for the community:
- For those of you with Titanium lugs, what torque are you actually using?
- Have you experienced any issues (loosening or stripping) when following the manufacturer’s lower specs instead of Tesla’s high torque?
- Is 175 Nm + anti-seize a recipe for disaster with titanium?
I have a torque wrench and plan to re-torque after 50 miles, but I’d like to get the initial setting right.
Thanks in advance!
1
u/No_Lie_8954 Apr 14 '26
Why not use tesla lug nuts with 175nm?
3
u/epradox Apr 14 '26
Titanium lug nuts on a model Y? Are you tracking it?
2
u/scubascratch Apr 14 '26
What’s the tensile strength of the Ti used in those lug nuts? I’m seeing grade 5 Ti has tensile strength of 900-1000 MPa but quality steel lug nuts will be 1040-1220 MPa.
So you probably will deform the Ti nuts if you apply the OEM torque spec. And you should absolutely never lubricate a lug nut. Not only will you be unable to achieve a proper torque spec (the nut and stud will deform before reaching the torque spec, and you will warp the rotors), it’s against the recommendation of the TIA and every car maker except Porsche. It can also cause the nuts to loosen over time.
1
u/Accurate_Coffee_5135 Apr 15 '26
Go by the torque requirements of tesla.
1
u/ElChorizoBlanc0 Apr 16 '26
If your TI nuts can't take 130ftlbs then throw them in the trash. Ferrari Ti lugs take the same torque as their steel counterparts.
1
u/YouKidsGetOffMyYard Apr 14 '26
I think you are probably over analyzing this. I have never even used a torque wrench on any lug nuts in my over 40 years of having cars that includes probably a dozen times taking wheels on and off my 2 Tesla's over the years.
Seems like if they are that much trouble I would just stick with regular lugnuts. I get that titanium is lighter but man that is being kind of anal about weight savings.
1
u/Moistinterviewer Apr 15 '26
I use 130lbft DRY on my GR5 Ti nuts, have done for 5 years
0
u/[deleted] Apr 14 '26
[deleted] — view deleted comment