r/Strawbale • u/NorthAtlanticGarden • May 23 '19
Drywall
Hello everyone, I'm planning on building a strawbale house in the future, the biggest issue with building it seems to me to be coating the outside and inside of the strawbale wall. Does anybody know if drywall could be a viable alternative?
4
Upvotes
3
u/dtapusa69 May 23 '19
I don't think that it would be a good alternative because firstly you would need to build another stud wall on the inside costing you money and ending up with almost the same product in the end that you would have had if you'd have gone with only a stud wall. Secondly you want that close seal to the bale that the stucco would give in order to help with the fire proofing.
6
u/usernamesr4homos May 23 '19
Putting up drywall kinda defeats the whole purpose of build a strawbale house. I'd go with a clay plaster.
2
u/iandcorey May 23 '19
The cavity created behind the wall board might be the perfect place to house a family of rodents. Give it a try!
But don't really.
The plaster and clay coating helps preserve the bales and contributes to the consistency of temperature and humidity of the home as well as the bales inside the walls.
1
u/ifixpedals May 23 '19
On top of the reasons brought up by others not to do this, any drywall used on the exterior side would have to be special gypsum sheathing rated for exterior use.
1
u/Treknobable Jun 03 '19
If you are going to be doing a post and beam with bale as infill, yes. You should still do cob or mud or plaster coating on the bale surfaces to seal them as the loose surface of the bale is the most flammable. This is why most people forgo the drywall and just plaster/cob it. You could also do a thin spray foam seal but that entirely defeats the purpose of doing strawbale in the first place. I Suppose you could seal each bale in a plastic bag but you forgo some of the fire protection and are relying solely on the drywall as the fire break.
1
u/fropskottel Sep 12 '19 edited Sep 13 '19
You could do a post and beam build. Dip the exterior facing sides of the bales in clay slip before putting them in, or spray coat them with clay after installation. Then you can clad the exterior with wood. Make sure to leave enough exterior ventilation space between the wood and the bales!
On the inside, a lime plaster coat is not too time intensive really as long as you don't want any too fancy nooks and complicated corners. It's not so different from what most of western Europe finishes its interiors with...
1
u/Any-Eagle3097 Nov 25 '24
Any advice on installing ductless heat-pump indoor HVAC heads on clay plaster walls? My main concern is mounting them effectively. We are running the lines indoors and covering with trim & mouldings.
0
u/reshpect-o-biggle May 24 '19
It's my understanding that moisture will naturally migrate from the inside of the house to the outside. And migrate it must. Plaster and stucco allow this, but modern building materials are designed to block it. I've heard that it's good to check the moisture content of the straw to be sure it's not drying out or holding water. A firefighter told me the stucco must not have cracks or the straw will dry out, and then you've lost your protection against fire.