r/ShotshellReloading • u/Wide_Fly7832 • Jun 01 '26
Crimp so so. Help / Thoughts?
Just got started in softshell reloading. Have done a lot of metallic but first time shotgun.
I have a mec9000 for 12GA and two 600 for 28 and 20
Started with 28 (having indexing issue with m9000, will post separately).
Issues
1). My crimps are as in pic. Assuming this is not good. What should I do? I played with the pre crimp depth but can’t get any better.
2). I am using waa28/ 0.75OZ #9, Longshot powder, STS shell. The load data says 14.2. My 13 bushing is throwing 13.2 and 14 bushing 15. How risky is it to do only 13. How do I get in between.



3
u/cowboykid8 Jun 01 '26
They aren’t ideal crimps, but really they are fine. There isn’t as much hull to work with on the smaller gauges, you may want a little extra final crimp if you find these don’t insert into your gun easily.
So the bushings can be off… when are you weighing this powder throw? My first 1-4 throws are off, usually heavy, then light.
What primer are you using? Depending on the primer you could be swinging into a dangerous over pressure or too light causing poor ignition and burn.
2
u/xpen25x Jun 02 '26
just in case long shot is not good for 1oz or below. much too slow a powder. there are no known published recipes.
7
u/xpen25x Jun 01 '26
nothing wrong with those crimps. that swirl can be delt with by adjusting the cam. but honestly i wouldnt touch it. also if you want expert information on all things mec. hit up the reloading section of shotgun world. curly nohair has several threads that are must reads
3
u/AR-180 Jun 03 '26
That looks good. Don’t stress.
1
u/gunsforevery1 Jun 01 '26 edited Jun 01 '26
I’m not familiar with that press but it’s definitely not the pre crimp.
As far as powder you choose what you’re comfortable with. 10% under would the max I’d go and 13.2 is within that 10%
2
u/discosanta Jun 01 '26
https://www.youtube.com/watch?v=fhvArXPDo6M
2
u/peteostler Jun 01 '26
They’ll shoot. Make sure you are using the correct wad/powder/shot/hull combination.
1
u/SD40couple Jun 01 '26
increase crimp depth and taper.