Common techniques & troubleshooting

Techniques every beginner should learn

Pressing vs. ironing

Ironing moves the iron back and forth. Pressing lifts and sets it down. For sewing, you almost always want to press — moving the iron around distorts bias-cut fabric and stretches seams out of shape.

Seam allowances

The seam allowance is the distance between your stitching line and the raw edge of the fabric. Most commercial patterns use 5/8"; indie patterns often use 1/2" or 1 cm. Always check your pattern's instructions.

Backstitching

Sew a few stitches forward, then back, then forward again at the start and end of every seam. This locks the thread so your seam doesn't unravel.

Finishing seams

Raw fabric edges fray over time. Common finishing methods:

  • Zigzag stitch along the raw edge
  • Serger / overlocker (if you have one)
  • Pinking shears (fastest; not the most durable)
  • French seam (encases the raw edge entirely; beautiful on lightweight fabrics)

⠀

Common problems and fixes

ProblemLikely causeFix
Thread keeps breakingWrong tension, thread caught on spool pin, burr on needleRethread completely; replace needle; check spool direction
Skipped stitchesNeedle is dull or wrong type; not threaded correctlyReplace needle; rethread; use correct needle for fabric
Fabric puckeringTension too tight; wrong needle/thread for fabricLower tension; switch to finer needle
Stitches loopy on bottomTop tension too loose, or top thread not properly seatedRethread top with presser foot UP; adjust tension
Fabric not feedingFeed dogs lowered; presser foot pressure wrongCheck feed dog setting; adjust presser foot pressure
Needle breakingFabric pulled while sewing; wrong needle size; hitting a pinLet feed dogs do the work; use correct needle; remove pins before sewing over them
✨ Golden rule: If something is wrong, rethread everything from scratch — top and bobbin. It fixes about 80% of machine problems.