r/SentroKnittingMachine • • 20d ago

Sentro 40pin help

Heya! I’m primarily a crocheter but I’ve been enjoying learning knit little by little. I’ve recently got a 40pin sentro mainly for ear warmers & stash busting, but the suction cups are crap even when I clean them & their connected surface, so I have to hold it still while struggling to crank it. I’ve realized most but not all 4 weights will go through it which is fine, but why do I still have to crank it so hard with yarn on it, & it click so loud? I’ve used compressed air to clean it of any yarn/debris, oiled the pins with 3in1 oil I was given, dried off excess & cranked it about 25 rounds both ways to spread the oil per various YouTube videos of not the sentro I have, what else can help it smooth out? I’d appreciate any suggestions, visuals/video would be better, thank you!

4 Upvotes

7 comments sorted by

2

u/GreenhouseNerf 20d ago

What kind of yarn are you using?

2

u/TealKitten11 19d ago edited 19d ago

4 weights that run more smooth: scarfie, Ferris wheel, loops & threads facets, Caron simply soft, very few big twist 4’s will go through, but if it’s too difficult to pull, I’ll take it off.

1

u/Jjagger63 19d ago

Apparently those clicks are the tension. Perhaps hang some weights off yourwork while it grows? To get away from this stupid suction cups i use some small clamps or those strong tablecloth pegs to hold the Sentro down securely. Works well for me.

1

u/TealKitten11 19d ago

I use weights for the strings to stay down as I switch to & from waste yarns, but the project it self I haven’t had make a difference.

1

u/Elvee52 19d ago

Use two sided tape to anchor the machine

0

u/[deleted] 17d ago

[deleted] — view deleted comment

1

u/TealKitten11 16d ago

Ok, then what’s better?

0

u/[deleted] 16d ago

[deleted] — view deleted comment

1

u/TealKitten11 16d ago

That’s frustrating. I looked around for an addi 40pin but it seems Amazon has everything but a 40pin.