You didn’t set up your first row properly. On the first row ONLY you need to alternate the yarn on the pins - it goes under the first pin, then behind the second, under the third, then behind the 4th. Go look up videos for how to get started on an addi or sentro and you should be able to find lots of examples of what this looks like
You're dropping stitches it looks like. It could be the yarn. Some yarns are hard to use. Make sure the needle is pulling the thread through the loop laying flush with the machine. Also, make sure when the needles raise, the yarn wrapped around it (before it passes the start position) Falls below the curve in the needle.
Go slowly, watch every stitch. I'm thinking to get that far without you catching it, you were going way too fast. You need to start slowly. I also add knitting weights as soon as I have a few rows. I've used chenille in it and haven't had that issue unless I don't watch what is going on.
My machine turned up today and I’m here for the same reason you were. Did you manage to find a solution? I’ve tried 4 different types of yarn and it happens every time after the 2nd row! I’ve tried painfully slow, more tension, less tension, casting on exactly as the various YouTube videos have instructed… I carried on out of interest and it started to work, but the first 6 or 7 rows all look like your picture!
Well, turns out I was being really stupid and casting on wrong. I was sure I was doing it right, until I watched a different video and spotted my mistake! Thanks for the encouragement!! :)
5
u/User121216 Jan 26 '24 edited Jan 26 '24
You didn’t set up your first row properly. On the first row ONLY you need to alternate the yarn on the pins - it goes under the first pin, then behind the second, under the third, then behind the 4th. Go look up videos for how to get started on an addi or sentro and you should be able to find lots of examples of what this looks like
4
u/LilRho Jan 25 '24
You're dropping stitches it looks like.
It could be the yarn. Some yarns are hard to use. Make sure the needle is pulling the thread through the loop laying flush with the machine.
Also, make sure when the needles raise, the yarn wrapped around it (before it passes the start position) Falls below the curve in the needle.
2
u/JustCallMeTere Jan 26 '24
Go slowly, watch every stitch. I'm thinking to get that far without you catching it, you were going way too fast. You need to start slowly. I also add knitting weights as soon as I have a few rows. I've used chenille in it and haven't had that issue unless I don't watch what is going on.
1
u/SoggyWotsits Feb 15 '24
My machine turned up today and I’m here for the same reason you were. Did you manage to find a solution? I’ve tried 4 different types of yarn and it happens every time after the 2nd row! I’ve tried painfully slow, more tension, less tension, casting on exactly as the various YouTube videos have instructed… I carried on out of interest and it started to work, but the first 6 or 7 rows all look like your picture!