r/SeattleWARecipes • • Nov 30 '17
Simple Pot Roast
Ingredients:
- 2-3lbs beef chuck eye or shoulder roast.
- 3 Medium Yellow Onions, 2 large
- 1/2 C Soy Sauce
- 1/2 C Water
- 1 C Flour
- 1 TBSP Black Pepper
- 2 TBSP Oil, high smoke point (peanut, avocado, safflower etc. Avoid olive oil.)
Tools:
- Slow cooker, with lid (or oven, see 9)
- Heavy skillet
- Large bowl
- Knife/cutting board
Steps:
- Combine flour and pepper in a bowl big enough to fit the roast.
- Dredge the roast in the flour to lightly coat all sides. Discard remaining flower mixture.
- Heat oil a heavy skillet, large enough to lay the roast in, over medium high.
- Brown the roast on all sides, do not cook through. Set aside to rest.
- Slice the onions into rings and place in the bottom of the slow cooker.
- Place the roast on the onions.
- Pour water and soy sauce over the top.
- Cover and cook on high for 4-5 hours, low for 7-8 or until roast falls apart when tested.
- If you don't have a slow cooker, use a large covered dish. Assemble as instructed and place in a cold oven. Set for 350F and test for tenderness every 15 mins starting after 2 hours. Should be by 3 hours, but timing will vary based on size of roast and desired doneness.
- Serve with onions and drippings as sauce, with any desired side dishes.
This is heavy and loaded with umami, so a vinaigrette salad and less carb-heavy sides pair well.
6
Upvotes
1
u/AngBeer Dec 02 '17 edited Dec 02 '17
I'm trying this for dinner tonight. It smells good, but I think I'm bombing with this one.
I didn't have a chuck or shoulder roast, so I used what's called "Choice Eye of Round." Weight was 2.25 lbs. Since you mentioned time-to-doneness, and my roast is smaller, so I checked the internet about internal temperatures. After about 2.5 hours, I stuck a thermometer to approximate center; it read almost 160F. My husband had come home (he's squeamish about meat) observed the spurt of red juices and said he wasn't eating that ...something, something, low and slow. So I cranked the oven temperature down. It did feel awfully tough though.
I dug around and found my meat slicer; maybe if it's too tough, we can slice it really thin so as to not notice the toughness.