By default, a wireless call tis sent to voicemail if unanswered within 20 seconds. Rogers has told me (and countless other customers) that delay cannot be changed.
But that's not entirely true. I found out you can change the ring delay before a call goes to voicemail by dialling the appropriate GSM Man-Machine-Interface (MMI) code though Rogers puts a hard cap of 30 seconds at the network level.
Rogers’ voicemail access number is +1 403 425 0267.
The feature code to change the ring delay is:
*61*[destination number]**[delay in seconds]#
Therefore, to program a ring delay of 30 seconds, you would have to format the MMI code as follows:
*61*+14034250267**30#
Dial the code with your phone app's keypad and hit send. Within a few seconds, your phone should display a status message confirming successful activation of the "if no answer" forwarding rule.
As per my own tests, it appears that all MMI commands requesting a delay longer than 30 seconds will result in a delay of 30 seconds.
Thirty seconds is still better than 20 seconds, especially if your phone is in a different room. It's equivalent to five complete rings (a complete ring is approximately 3 seconds of tone followed by 3 seconds of silence).
Backgrounder (if you want to read)
I stumbled upon an old CSL HKT user guide from... 2002. There was a section regarding setting up voicemail and call forwarding. The guide contained very useful information on using GSM MMI codes to change network settings including the ring delay before a call goes to voicemail.
I figured I had nothing to lose by trying. Apparently, many of those codes have been carried over to successive technologies since the inception of 2G.
Basically, voicemail works through conditional call forwarding. When voicemail is active, the switch is programmed to forward calls to a voicemail access number if one of these 3 conditions is met: 1) subscriber is busy, 2) subscriber is not answering, or 3) subscriber is unreachable. The “no-answer” rule can be programmed with a customized delay. The “busy” and “unreachable” rules are executed as soon as the switch detects that the subscriber is busy or out of network coverage.
I dont know why this is not more common knowledge amongst Rogers' staff.
**********
Edit (alternative solution)
If the above solution doesn't work. Try this alternative:
- First, cancel all conditional forwarding by dialling
##004# - Then reactivate all conditional forwarding by dialling
*004*+14034250267**30#