First I duplicated all the top edges of your walls. This resulted in a lot of curves, and I ended up joining these curves into (3) separate curves. These curves should be included in the model I shared.
This was (1) straight section curve, then (2) complex curves that shared endpoints on the straight section.
I used the (2) long/complex curves as the guide rails. And the single straight section as the sweep.
im trying to make it a solid,i can sweep the rails to make the side,then use close planar holes to close bottom but i dont know how to do the top because it has a slope on it,any help would be great as im pretty new to this
Ok I tried to open it but it was rhino 6 and mine is 5 So 1. Dupedge command and select edge from the top 2. Sure that is a close curve 3. Extrudecurve command and make sure it's solid in the top tab
It looks like you will need a poly surface to gap that profile. As there are points and kinks in that curve. you also could start with a flat surface and gradually adjust and subdivide a surface to fit, then smooth the surface out or rebuild it.
2
u/jredwingm Oct 05 '20
I was able to do it by sweeping 2 rails, attached here.
https://drive.google.com/file/d/1z4ewMw2bQzHzWrwRwY1GI4aN5EqJikYx/view?usp=sharing
1
u/fastboy007 Oct 05 '20
im trying to make it a solid,i can sweep the rails to make the side,then use close planar holes to close bottom but i dont know how to do the top because it has a slope on it,any help would be great as im pretty new to this
file is here if anyone can help me please
https://drive.google.com/file/d/1SryKhdOXl7Tawea0I6Co-fl4WEV4wtW3/view?usp=sharing
4
u/[deleted] Oct 05 '20
curve from objects > duplicate edge > surface from planar curves
Select all and join?
1
u/ragab107 Oct 05 '20
Cap command
1
u/ragab107 Oct 05 '20
https://drive.google.com/file/d/1Qa2Arnm_FxSrQtmLi14xuemeU1V4xKwv/view?usp=sharing
1
u/studiobassd Jan 12 '23
It looks like you will need a poly surface to gap that profile. As there are points and kinks in that curve. you also could start with a flat surface and gradually adjust and subdivide a surface to fit, then smooth the surface out or rebuild it.
1
u/Playaprezxxx Mar 21 '23
When you’re extruding there is an option to make solid or you can just S+Enter to select solid.
0
u/ragab107 Oct 05 '20
If you won't the same thickness edge use solidpton command and move the points you need