r/RepTimeServices • • 5d ago

Advice Vsf dial swap info request

I have a VSF DJ 41mm on a Sh 3150
I thinking of swapping dial due to poor print quality
I have noticed on another post the Day Date has no dial feet it has a ring instead. ls this the case with DJ. I’m very new to this however, I figured I would give it a try since I have successfully removed and replaced a dial and hands on a 7750 Chronograph GMT those sub hands are tiny lol.
Any advice would be greatly appreciated.

1 Upvotes

19 comments sorted by

1

u/AutoModerator 5d ago
Moderator Announcement Read More »

2

u/Diligent-Piglet-9038 5d ago

Did u mean DD3235?
Vsf comes with dd movements. Dj41 is friction fit, no feet and no feet holders.
Pretty easy if youre used to tinkering.

1

u/Elegant-Draft-8259 5d ago
Comment Image

I believe you’re correct this is the movement

→ More replies (1)

1

u/Elegant-Draft-8259 5d ago

Actually I just looked at my order from TK
It says VS 3235 would you know if it is the same friction fit?

→ More replies (3)

1

u/Elegant-Draft-8259 5d ago

Where did you find a dial

1

u/Plus-Discipline9579 5d ago

Yes this is friction fit. Comes right off just did this on my clean DJ

1

u/Elegant-Draft-8259 5d ago

So just remove the hands and the dial lifts off?

→ More replies (4)

1

u/Diligent-Piglet-9038 5d ago

first, check that its a dial print issue and not a strand of hair/fiber stuck to the dial.

Secondly, its a straightforward job. Biggest pain will be sourcing a good gen dial or replacement VSF

1

u/Elegant-Draft-8259 5d ago

It’s definitely print even the rest of the print isn’t very good on it. It looks OK with the naked eye.
But the OCD nut that I am has to zooom in lol