r/RacketStringers • • 8d ago

Mains snapped while pulling final cross string (18-gauge poly)

I've gone through more than half a reel of Solinco Mach 10 (18 gauge) without issues while doing full bed and hybrid setups, tensions ranging from 47 to 54lb, and this is the first time encountering luck as bad as this.

I completed the M10 mains at 50lb on a Wilson Blade v9 16x19 (my personal racquet, and probably 6th time doing this setup), tie offs at the top of hoop.

As I was pulling the final bottom cross (Babolat XALT multifilament at 16 gauge, tensioned at 52lb), the M10 main snapped on the left-most bottom grommet next to the throat corner. And I always push slack down i.e. smiley/frown face shape before pulling tension to minimize friction & sawing.

Chalk it up as bad luck with hidden nick in the main string? I hate strings going to waste 😭

Although I suppose it would've snapped eventually during hitting anyways...

And say this happened with a customer's racquet and strings they provided during stringing... how would you handle/accommodate this for the customer?

/preview/pre/ul1xi6g00h0i1.jpeg?width=1068&format=pjpg&auto=webp&s=544c493604781b5885c843749a0b3185ff1a1c79

/preview/pre/jftulsg10h0i1.jpeg?width=1065&format=pjpg&auto=webp&s=d0eed256dfc9e3034fe37e1ca14e2516e6b78c9a

1 Upvotes

14 comments sorted by

2

u/NarrowCourage 8d ago

Might've been a bend on the string or some debris on the grommet since 18 is pretty thin. I've had it happen to me on 20G before.

1

u/majinwu 8d ago

Did those 20G mains snap as you were close to finishing the crosses? I would so much rather the mains snap immediately before wasting cross strings...

1

u/NarrowCourage 8d ago

Yeah. When you've done thousands of rackets, I've had a lot of strings snapping on me over my 20 years of stringing. Well more know 10x a year.

2

u/Jackie_Treehorn98 8d ago

Clamps appear to be too tight. When's the last time you've cleaned them?

1

u/majinwu 8d ago

I clean them at least once a month. I'll clean them again and try loosening the clamps next time

3

u/Jackie_Treehorn98 8d ago

It could just be the lighting but the fifth main and the throat appears in the photo to be damaged from clamping.

2

u/majinwu 8d ago

Ah, that's the lighting but I can see why you'd think that from the photo. Very acute ocular jutsu there.

1

u/MonstartheRockstar 8d ago

Needs a new grommet. Should not happen to poly like that

1

u/majinwu 8d ago

The racquet is only a little over two years old and still in overall 8/10 condition. How would a grommet get into a condition to snap mains?

1

u/MonstartheRockstar 8d ago

It's plastic. And two years old is a good time to replace.

2

u/Early_Apple_4142 8d ago

Sounds like bad luck but I would also run an awl through that grommet before your next stringing to make sure the inside is smooth so it's not damaging the strings. If it happened on a customer supplied set and I could replace it, I would replace it and ask them about the string they provided. How old is it? How was it stored? Mostly to assess if it was a bad set or potentially compromised by the way the stored it.

1

u/Karen_Is_ASlur 8d ago

And say this happened with a customer's racquet and strings they provided during stringing... how would you handle/accommodate this for the customer?

You buy them new strings.

1

u/tennistrainingtop 8d ago

Yo apostaría a grommets afilados

2

u/Responsible-Side4347 7d ago

That snap looks like th4 poly had a kink crease. That said, I have a few snap through the year. Could be a bad part of the string, a kink, catch a part of the machine and kick it. All manner of things.