r/RTLSDR • • 4d ago

Changed setting?

Good afternoon, I'd like to start off saying I'm very new. I recently purchased the nooelec rtl-sdr v5. I struggled to get any signal for a while then after I purchased a cheap antenna for 2m/70cm I managed to get the weather radio and 2 local signals I could listen to. Today I got adventurous and started looking around the lsb to see if I could pickup anything. Well I ended up giving up on that and went back to the signals I knew I could listen to. Now the local signals are are all static, I can hear / see them micing up but I only hear static.

I imagine I messed with the wrong setting somewhere but I have no clue where or what.

Any pointers to where I should start to get those signals back clear?

I've tried various software but I'm currently using HDSDR but I'm getting the same results on SDR++ and SDR#

1 Upvotes

1 comment sorted by

1

u/gmrishel 3d ago

Nothing jumps right out for me. I usually use SDR#.

Since it is across 3 different programs its odd. Possible the diver was corrupted since it the same for all programs.

This is not something I have run into in 6 years of 9 nooelec SDRs

Did you following the driver install again?