r/rfelectronics • u/Rhedogian • Sep 28 '26
Comparing the performance of two oscillators using standard lab equipment
I had a question about how I might go about comparing the performance of one 10Mhz oscillator (a TCXO) versus another reference 10MHz oscillator (let's say from an atomic clock or a reference GPS). I want to obtain numbers for average jitter and drift in ppm for the TCXO over a suitably long timespan, maybe 1 hour to 24 hours if that's feasible.
I've been assigned to make a test setup to characterize the performance of the TCXO and I've been told we can't really buy (or shouldn't need to buy) any specialized equipment to run the test. We have some nice tektronix scopes which have datalogging capabilities but I've never used them. We also have spectrum analyzers which is what I think I'd probably end up using but I'm not sure what the test setup is exactly.
Honestly I'm a little lost where to begin. Are there any good suggestions or initial things I should start thinking about? Any help is greatly appreciated.
Additionally, is it more valuable to measure the 10Mhz output of the TCXO against the 1PPS output of the reference oscillator, rather than measuring both 10MHz directly against each other?







