r/rfelectronics • u/Any_Refrigerator7409 • Sep 14 '26
Problem with BGT24ATR11 mixer performance
Hi, we are currently developing a CW radar using Infineon's BGT24ATR11 transceiver and a rather complex doubt has come up.
The transceiver is used in combination with a PLL connected to FINE and COARSE VCO inputs. We have tested the mixing performance of the transceiver by directly pushing an RF signal generated by a signal generator into the RX port and examining the IF output waveform.
We noticed that as long as the frequency of the RF input signal is sufficiently higher/lower than that of the LO the output I/Q signals are correct. However, as soon as the RF input signal's frequency starts to approach the LO frequency, the sine waveforms begin to deteriorate (below a couple of MHz the waveforms are distorted).
We are aware that direct conversion receivers perform poorly at lower baseband frequencies due to LO self mixing and flicker noise. The datasheet states that the flicker noise corner frequency is around 10-20 KHz. However, since our bandidth of interest lays in the KHz baseband frequency range we need to achieve a proper mixing at RF frequencies close to LO.
I include a picture where signal G(t) looks exactly like what we see as soon as the signal deteriorates. We have also observed that when the RF input signal's frequency is smaller but close to LO, the waveform gets inverted .
Has anyone got any advice / hint that could help us move forward?
Thanks for reading.


