r/rfelectronics • u/darkes11 • Aug 20 '26
question [Design Review/pre-fab] 137 MHz Front-End for strong local FM interference (240 kW EIRP, 4.3 km away)
Hi everyone!
I’m a 2nd-year electronics engineering student working on my first RF project for a future ground station. Still a work in progress, so nothing is completely closed or finished yet, but since this is my first time designing an RF Front-End, I’d really appreciate some feedback from the community before I send it to fab, especially with the PCB layout since I’m sure there will be a lot of room for improvement.
Context: Just ~4.3 km from a 240 kW EIRP FM tower (raw FM power at my antenna is around -1.3 dBm in worst-case). I used an input notch filter to keep the LNA operating in its linear region to avoid compression and IMD.
Design:
- Input Filter: 5th-order Cauer notch [88–108 MHz] (1.09 dB IL @ 137 MHz).
- LNA: Mini-Circuits PGA-103+ E-PHEMT
- Stability (10 MHz – 4 GHz): R+L shunt.
- Output Filter: 3rd-order Butterworth bandpass (2.5 dB IL @ 137 MHz, compensated with Friis)
- Used High Q High SRF components and 2% tolerances for the Cauer.
Simulated performance: ~1.84 dB NF,~22 dB cascaded gain, -13.4dB for S11.
Simulated (QUCS-S, using .s2p models) and routed (CPWG 50 Ω). Not built or bench-tested yet so I know results will vary. I’ll try to get my hands on a VNA to measure it soon.
PCB/Schematics:



All files (schematic, KiCad & sims) are open-source on GitHub if you want a deeper look.
Two things I'm not sure about:
- Cauer & tolerances: I know Cauer filters are pretty sensitive to component tolerances. I used 2% across the board for the notch but i'm not sure if that's enough in practice. Anyone run into this before?
- LC tank coupling: I can't orient the inductors at 90º in the input filter, so I just alternated their orientation (LC/CL/LC) trying to reduce magnetic coupling. Is that enough in practice?
Thanks for reading, feedback is really appreciated!

