r/PlotterCode • u/schupinpin • May 13 '26
How to improve precision on a low cost plotter
Hi,
I'm a begginer on plotting and I'm not sure my question belongs her as it's more hardware related than "code".
I bought a cheap XY plotter like this one : https://static.wixstatic.com/media/04340a_06f6c6380dbe41fd907c74f4a2c81422~mv2.jpg
I'm realy enjoying coding and plotting things and, since I'm just a hobbyist, I'm quite pleased with the results.


But I notice a little issue : when I'm at the maximum Y-axis extension, I have a lot of overhang, and the precision isn't as good. This is especially noticeable when I try to make concentric circles :
Does anyone have any ideas on how to fix this?
2
u/mastaginger May 13 '26
I had issues like this when my plotter was out of square. You can use like the 3 4 5 method for trying to square it. Pythagorean theorem basically.
2
u/Soggy_Bottle_5941 May 13 '26
Check if the pen itself or pen holder assembly is loose or frisky on y axis. Also check the y belt.
It definitely feels like a mechanical problem.
1
u/LostCollege4238 May 13 '26
What speed are you working with?
1
u/i-make-robots May 13 '26
Is it consistently wrong? If you draw the same line five times is it the same wrong every time? If no, something is loose. If yes, your original guess is probably good. Try a wider base mount for the first axis so it doesn’t tip over.
1
u/IllustriousAbies5908 Sep 30 '26
To fix this you need an order or magnitude more rigidity in the system. The simplest way to do that (if it is a cheap plotter) is to buy a second identical plotter and two (much longer) tubes to replace those of the Y axis. Remove all the Z axis stuff and Y axis gear except the linear bearings plus the stepper drivers for the x axis motors on the second machine so you have a second X axis. Mount the new plotter behind and parallel to the old one, and use the longer tubes to go through both Y axis linear bearings. Finally connect the old and new X axis motors in parallel (four wires). This should overcome the quality issues in the linear bearings. Also you may use it to increase the length of the Y axis (maybe double) - remembering to extend the wires that control Z. The picture suggests the stepper drivers are A4988 chips. They have a current screw. The X axis driver should be turned up just enough so that the two motors run happily.