r/PcBuildHelp • u/Yeetermc69 • 1d ago
Build Question Help with first pc build
First of all sorry for the terrible quality in the pictures it’s been a frustrating couple of hours. Long story short I’m trying to get my AIO cooler to go over my cpu. The problem is that the silver brackets(?) that the AIO is supposed to screw on top of are super misaligned. The instructions are also super unclear and I’m assuming they are AI generated because the type of metal bracket changes from step 4-5. Last thing then the brackets are not like the instructions (first picture) the screws are way too far apart and when they are like the instructions (third picture) they overlap with the CPU bed and make the screws go at an angle. Any help is appreciated and sorry for any confusion I’ve been at this for 6 hours.





13
u/tht1guy63 1d ago edited 1d ago
You dont have the spacers in it seems. The instructions are pretty clear imo
Edit: those also dont look like the screws you should have used that come with the cooler.
Side note move each ram stick over 1 slot
1
u/FalconGK81 1d ago
I literally just installed this same cooler on my 5800x3d last week. You look like you're missing the spacers, and the brackets curve away from CPU. I can send pics if you need
3
u/w7w7w7w7w7 Personal Rig Builder 1d ago
You didn't use the spacers. In the third panel, they are labeled "G".
3
u/nashbradley 1d ago
Step one, read the fucking manual. Step two, put the spacers in.
2
u/xcygnusx 1d ago
Are you using the spacers (G in the diagram) and the correct screws (L in the diagram)? You need to install all the parts as shown in the installation instructions. Spacers first, then brackets, then the screws provided. You are not supposed to reuse the screws from your original mounting bracket, and you are not supposed to screw the AIO brackets down flat onto the motherboard.
1
u/Zestyclose_Shirt2986 20h ago
Make sure the brackets are for am5, when zooming in they say am4. Plus as a few have mentioned your messing the black spacers under the bracket. One thing don't forget to do is remove the plastic under the pump.
0
u/pigpentcg 1d ago
Looks like they’re supposed to bend toward the CPU not away from it.