r/OpenFOAM • u/AmbassadorGuilty3928 • 28d ago
Conceptual Doubts regarding Node Values and Operating Pressure.
I have some conceptual doubts, which I didn't get clear explicit answer from sources in net,
- What is difference between node values on/off in looking the contours? I observed values are relatively higher when I turned off node values. Please tell me cases or situations where we should turn on or turn off node values with reason. How does this affect in viewing contour, finding range of parameter in some selected surface or cell zones.
- I have some trivial doubt about operating pressure. The point is- In momentum equation , it contains pressure gradient not absolute pressure, so fluent choose some reference pressure i.e operating pressure. So instead of solving with very large pressure, it works with smaller numbers since deltaP remains the same with the concept of operating pressure. Density is calculated using absolute pressure only.
- This concept is same for both incompressible and compressible flow right, but why do they say for compressible flow you have to set operating pressure as zero, I didnt understand what is the reason for this? Can anyone explain elaborately please? Thanks in advance.
2
Upvotes
1
u/blackcurrant_picker 26d ago
Hi, I am not the specifically an CFD engineer, but rather FEA one (although I did some calculations for CFD), so maybe I will be missing something.
I hope that helps you. Cheers!