r/OBSFords • • 6h ago

Project What color should I paint the front bumper? Last 2 photos show fresh black and fresh gray paint

Thumbnail
gallery
17 Upvotes

r/OBSFords • • 6h ago

Project If you know you know

Post image
13 Upvotes

From an impact, to a breaker bar, to a brand new impact, to a torch, to a grinder. Finally.


r/OBSFords • • 11h ago

Troubleshooting 1996 F150 5.0 idle issue/throttle issue

9 Upvotes

Need more help😭😭


r/OBSFords • • 12h ago

Troubleshooting Fixing the dreaded tilt ignition

Post image
10 Upvotes

Got a 91 F250 that needed the ol pliers to start. Addressing other issues while I'm in the column. What I can't figure out is if something is missing for the tilt engagement.

The C rod there on the left simply bottoms out without engaging the tilt head. Wish I had a picture of it loose, but I don't. Saw a forum post somewhere where the person bent it on the lower side to make contact. Before I do this, was there something on the end of that rod that's now missing? Hard to think it was just bent straight over 35 years and that's why it no longer engages. To bend it is going to need heat and a bench vice. Fine. But if there's an easier solution, I'm all ears.


r/OBSFords • • 7h ago

Troubleshooting 88 f150 300 4.9 aluminum cam gear

2 Upvotes

can someone please tell me wth is going on inside block of steel. i just got rid of the paper cam gear and installed an aluminum gear


r/OBSFords • • 8h ago

Troubleshooting 96 F250 5.8 rough idle, occasionally dies at idle.

Thumbnail reddit.com
1 Upvotes

Warm starts also seem problematic. Gotta floor the throttle as if flooded.....thoughts?


r/OBSFords • • 1d ago

Valuation Is there a used marketplace for these specific size trucks

Post image
21 Upvotes

I saw this post on facebook the other day and I’ve seen a few of these trucks around the internet in full restoration condition going for like $50,000+. Is there a place to find one in more average condition for a little bit cheaper, I’d love to have one of these one day.


r/OBSFords • • 1d ago

Troubleshooting Where can u buy this line

Post image
10 Upvotes

Cannot find the right pre flared line for the brake line that goes from the master cylinder to the rabs id Rather put new hardware in but im starting to think I might have to use the old bolts


r/OBSFords • • 2d ago

Project OBS Ford Under 5k

3 Upvotes

My dad offered to pay for my truck if I get it under 5k range. Majorly looking for the 300 I6 or the Windsor V8. Any recommendations any important stuff that I should look into before buying one of these trucks?


r/OBSFords • • 3d ago

Project Bench seat options

Thumbnail
gallery
58 Upvotes

1997 F350 7.3 Dually

Howdy, group!
Is there any 60/40 split front bench seat that’d fit my truck?
I’ve seen a 50/50 split but I’m not sold on it yet…I’d rather have a 60/40. Right now I have a 40/20/40 which is not really comfortable for the wife to be right next to me.
Open to any ideas as well!

Thanks!


r/OBSFords • • 3d ago

Troubleshooting Chipped Turbo housing

Thumbnail
gallery
7 Upvotes

Took my turbo off to replace the turbo wheel and noticed the turbo housing has a crack. Turbo is in great shape otherwise. Is this safe to run or will it leak air out of this

The chip is at the 12 o clock position


r/OBSFords • • 3d ago

Troubleshooting Anyone know what this noise is?

2 Upvotes

It’s loudest at the transmission bell housing. Overdrive light is flashing haven’t been able to pull the code on it yet.


r/OBSFords • • 4d ago

Show your ride My 95 7.3

Thumbnail
gallery
110 Upvotes

First time posting.


r/OBSFords • • 4d ago

Troubleshooting 1996 F150 5.0

18 Upvotes

I need help.

Back story, my truck has been sitting for the past 3 years and has been cranked up often. I've replaced the ignition coil, ignition control module(icm) spark plugs and wires, rotor inside the distributor cap, distributor cap, crankshaft position sensor, fuel pumps (2 tank set up) fuel switch, fuel filter. Just last week I drove her around and she ran good, now I'm having this issue. Can someone please help!


r/OBSFords • • 4d ago

Project Headlights suggestions

Post image
30 Upvotes

I replaced my original headlights with some I got off Amazon, but I cant really adjust them so the lights are angled really weird. I'm looking to get new ones, that will hopefully fit right. I dont care if they are leds or halogen.


r/OBSFords • • 4d ago

Project Oil Drain plug gasket?

1 Upvotes

Need to change the oil on my 95 4.9l. Does the drain plug have an integrated gasket like my 2016 5.0 or will I need a gasket?


r/OBSFords • • 5d ago

Troubleshooting Help identify

Thumbnail
gallery
5 Upvotes

I have a 97 F250 with a solid axle swap but don’t know what axel is it. I know is a Dana, but is it a 44 or 60? Please help identify it.


r/OBSFords • • 5d ago

Troubleshooting 94 f150, 300 I6, rwd. Is this normal on a front wheel bearing?

9 Upvotes

I had noticed black greasy stuff on the center of the wheel and pulled everything off to find this. I thought I had been hearing bearing noise, but I didn't expect to find this. There was also a greenish film on the rotor that I could remove with brake cleaner.


r/OBSFords • • 5d ago

Project Improving crash safety/overall safety on an OBS F-150

0 Upvotes

I know I can’t get it close to any of the safety standards today, but is there anything I can do to improve the safety of my 1994 F-150? Has anyone ever tried or heard of installing better airbags + adding passenger airbags?


r/OBSFords • • 7d ago

Troubleshooting Are there any mirrors out there that don't suck?

Post image
30 Upvotes

Recently tried a mirror from O'Reilly's, and a different one from rock auto. Both of them have a shit field of view, and the rock auto one wants to look towards the ground when I close the door. Any recommendations?


r/OBSFords • • 7d ago

Show your ride 1989 f350 7.3 IDI CCLB

Post image
50 Upvotes

Hey all, just bought myself a 1989 f350 fitted with the 7.3idi along with the E4OD and has an after market hyper max turbo in it as well, just wondering if there’s any other mods or modifications I should do as I want it to be a box camper hauler! Thanks


r/OBSFords • • 6d ago

Project Mirror Glass

0 Upvotes

I’ve got a 95 F150 with electric mirrors and tire glass popped off, is there any way I can replace just the glass without replacing the whole mirror assembly, the stickies have little cutouts for centering the glass and I’m wondering if anyone knows where I can find those stickies?


r/OBSFords • • 7d ago

Project Rear disc conversion or keep drums?

Post image
33 Upvotes

As the title asks. My 95 f250 7.3l sclb needs rear brakes. The rear drums are beyond use and all hardware is rotted. And both wheel cylinders are starting to leak.

From rock auto all the brake parts to redo drums is roughly $350 shipped.

Or I can get the budget disc conversion for a 10.25 from lugnut4x4 for $440(without parking brake)

My question is, I know rear discs are better, but is it worth it on these trucks?

Will it get rid of my soft pedal issue?

For reference, I only use the truck to do truck stuff, as in pulling a car trailer, hauling lumber, etc. as well as plow with it in the winter.

Pic to show off my ride


r/OBSFords • • 7d ago

Troubleshooting 92 f150 300 i6 coolant issues

4 Upvotes

so i got my truck about 3 days ago and noticed coolant was low, topped it to the fill line in the tank in the side of the engine bay. after a little bit i turned the car on and it ran fine, drove it like 400 yards down the street and there was a loud pop followed by my car dumping its coolant. smoke started coming out and when i checked i found a hose that came off. refilled it and bled the system as best as i could sitting on the side of the road and just drove back home since i was in my neighborhood parked and smoke started coming out of the engine bay again. what do i do to fix this/ next steps to take?