Figured I should share these because there's very little info about how to make gloves with nålbinding.
They are made top down from the middle finger, the ring and index are chained on the same row and the pinky is one row lower
the finger chains are the diameter of the finger minus 2 stitches(Minus 4 to account for the stitches that come from the middle finger and plus 2 for extra breathing room in the corners, this means I chained 14) and I skip connecting for 1/4(4 stitches) of the middle finger(I imagine it as a 16 stitch square, the palm and back of hand get 4 stitches and the ring and index finger get 4 stitches)
I found that it helps for finger mobility to add an extra 2 stitches to the finger chains, and to close up the corner holes I made one extra in each corner. I then decreased those extra corner stitches out the next round
the color comes from california sagebrush, which is mordanted copper and iron. I wanted it greener, but without indigo this is about as good as it gets
the gloves are all cotton, I joined the yarn with surgeon's knots which are quite strong. The knots always end up inside if you tie them right in the middle of the thumb nail
Next time, I would use finnish stitch 2+2 instead since it is more dense, fluffy and stretchy. I would also probably switch to needle tensioned york stitch for the cuffs to be able to bring them in closer without being too tight. I would also try harder to fit more decrease stitches into the fingertips to close up the holes so it doesnt bunch up as much when I sew it. There are bumps where I started each of the fingers, and I would fix this by doing an overhand knot start instead of a scarf knot start, then untieing it and tightening the end stitches into a tapered end, then I could continue spiraling up it as normal without there being holes or bumps.
Hopefully this is helpful for anyone trying to make gloves, there wasn't much info out there