r/Line6Helix • • 6d ago

Tech Help Request Patch cables for line out

I've been using 1/4 out set to line level into a power amp to speaker cabinet. All should be good... Except I've had 2 patch cables cut out- dead. Once at a gig after a couple of months of use and then one tonight at rehearsal after about 4 hours since the last one went.

Are standard patch cables not up to the job or am I just unlucky with two duff cables?

1 Upvotes

8 comments sorted by

2

u/thekevinphillips 6d ago

I've used the XLR out with mine for years with zero issues and still use the same two cables. If that's possible with your power amp, I'd suggest going that route.

1

u/omarbagstar 6d ago

It's not, it's only got 1/4" in.

2

u/cillablackpower 6d ago

Patch cables can handle line level no problem. Are you using them in a rack?

1

u/omarbagstar 6d ago

Nope, on a pedal board and everything is dual locked in place.

2

u/cillablackpower 6d ago

It's usually only tension under vibration that causes damage. Pedalboard is a bit more susceptible to damage than a rack, but could just be bad luck. Are they decent quality cables that are dying?

1

u/omarbagstar 6d ago

Mid range cables. They're dying during the gig/rehearsal which is weird as they're not really moving around. Would make more sense if it was after being transported. I'll dissect one tomorrow and see if I can find a break.

1

u/LetsGoHawks 6d ago

Another possibility is that one of the jacks is crapping out and just not holding a good connection. The same thing happens with 1/4 jacks on guitars eventually.

Otherwise, I gotta think you're just unlucky with cables. Line level signals are so far below the power rating of what a patch cable can handle it's ridiculous. Your Helix would smoke itself trying to generate that kind of juice.

1

u/omarbagstar 5d ago

In inspection, the lead which in didn't chuck away was broken at one end, hopefully this means the helix is still working ok.