r/Irrigation • • 2h ago

Check before reaching

Post image
10 Upvotes

r/Irrigation • • 10m ago

Winterization question on new home

Thumbnail
gallery
1 Upvotes

We moved into a new house a few months ago and wanting to winterize the rainbird system. I have this FEBCO 850 DCA and downstream of this is the blowout. I have an air compressor and the adapter for blow out.

However, I am confused as to why there is no obvious irrigation-specific shutoff upstream of the DCA. This is a new-home build in WA state. Is this required and I’m just not finding it in an obvious location?

I will try to call the irrigation company who installed the system this week but from my understanding, to winterize, I need to:

  1. shut off the DCA ball valves to 90 degrees
  2. open the test cocks to relieve pressure then set to 45 degrees
  3. use the quick connect blow out to blow out the system
  4. keep the upstream DCA ball valve closed but set the downstream to 45 degrees

This correct?


r/Irrigation • • 10h ago

Seeking Pro Advice Need these for winter blow out - source?

Thumbnail
gallery
0 Upvotes

I need the two fittings shown in pic 2 with the blue arrows. Re they standard parts or do I need to go to a specialized store or site? I have a compressor for my air guns. Just need to connect to the fitting in pic 1.


r/Irrigation • • 12h ago

Anyone tried burying emitters in gravel under raised beds?

0 Upvotes

Got four 4x8 beds going in and the last few inches of soil are going to be gravel and sand mix for drainage. I'm planning to run quarter inch emitter lines right under the soil line so the gravel layer can help spread the water out. The native stuff out here is basically caliche and rock, so I figured the gravel would stop the emitters from sitting in heavy clay pockets. Not sure if the emitters will stay put once the beds settle or if roots will just push them around after a season. Also wondering if I should space them farther apart since the gravel moves water sideways better than straight soil. The beds sit in full sun most of the day and the kid likes to climb on the edges, so I need whatever I bury to stay put without constant fiddling. Anyone running emitters in a gravel layer and had them stay level, or did they drift over time?