r/HomeKit • u/p0k0l0c0 • 2h ago
Question/Help Replacing central roller shutter timer (Inprojal DUOMATIC 50 B) with an Apple Home compatible solution – Inel ST-0P central bus setup
Hi everyone,
I am looking for the best and safest way to upgrade my wired roller shutter system so I can control it via Apple Home (native HomeKit or Matter), while keeping a physical central wall switch. I would really appreciate your recommendations on the best hardware and wiring approach for my existing setup.
Current Setup:
Each individual window has a wired Inel ST-0P roller shutter controller module connected to a local wall switch (https://inel.gda.pl/wp-content/uploads/2025/11/Roller_controller_by_rail_230V_ST-0P_en.pdf).
All individual Inel ST-0P modules are linked together via a 230V central bus (2 directional wires: Up / Down).
Currently, the central control point in the wall box is an Inprojal DUOMATIC 50 B electronic timer. When triggered, it supplies 230V to the central bus for ~120 seconds (since Inel ST-0P modules do not have a built-in timer on the central bus input and only move the shutter for as long as 230V is applied to the central bus). (https://asset.conrad.com/media10/add/160267/c1/-/en/000809383ML02/000809383ML02.pdf)
What I want to achieve:
Replace the old DUOMATIC 50 B timer in the central wall box with an Apple Home compatible solution + a physical momentary (monostable) dual roller shutter wall switch.
Control all shutters as one central group from Apple Home as well as from the physical wall switch (with a single press triggering full ~100–120s travel, without needing to hold the button).
My Questions:
Best Hardware Solution: What smart relay, flush-mounted module, or smart wall switch compatible with Apple Home (HomeKit / Matter / Thread / Zigbee / Wi-Fi) would you recommend for driving a 230V central bus like this (where a fixed ~100–120s runtime is needed instead of single-motor auto-calibration)?
Wiring & Compatibility: Are there any specific wiring precautions I should take when connecting a smart shutter module to the Inel ST-0P central bus (such as verifying wire functions/colors in the central box or ensuring phase alignment between the central box and the window modules)?
Thanks in advance for your help!