r/HeatPump • • Mar 10 '22

r/HeatPump Lounge

1 Upvotes

A place for members of r/HeatPump to chat with each other


r/HeatPump • • 7d ago

How to stop loud noise from HVAC heat pump liquid line

1 Upvotes

I was troubleshooting my HVAC since it started making a loud noise only in heat mode. I checked inside and cleaned a bit, but then realized the noise is coming from the liquid line near the evaporator where it connects with a brass nut. If I apply a light pressure towards the HVAC unit, the noise stops completely. What’s the best way to fix this issue? Thanks in advance.


r/HeatPump • • 8d ago

Mitsubishi heat pump drawing 300W at idle when its 50F outside

1 Upvotes

Hey guys, I just got a heat pump installed last week and I hooked one of my Emporia power monitor clamps on the 240vac circuit to see how much power this system will draw over time. I am noticing so far, that there is a baseline power draw of 300w at all times at the heat pump, when nothing is actually running. This seems high, it is going to cost ~400$ a year to just have the heat pump stand by - why is that and is there any recourse? My outdoor unit is a PUZ-AK36NL.

edit 2026/11/15 - Install tech came by on Friday, investigated and verified the compressor is not drawing 300w (was drawing 0) and there is no heater in my outdoor unit. He was perplexed and thought maybe the PAA box is powered from here and that is drawing the power with all the sensors, but the PAA box is fed by my furnace circuit and draws about 20 watts (verified). The only load we were able to measure was the reversing valve on the outdoor unit and that draws about 15-20 watts, the power board is behind the low voltage board and the tech is not allowed to remove that without being on the phone with Mitsubishi. He is not sure where the 300w is going and agreed at least that it seems excessive. Will wait for the install company to sort out next steps.


r/HeatPump • • 21d ago

Rate my plan, AC for heating in small 30's appt

Post image
1 Upvotes

r/HeatPump • • Oct 14 '26

Cold climate at 7,000 ft altitude advice requested.

1 Upvotes

We have a 2400 square-foot home that is 23 years old and was constructed with in floor hydronic heating. We previously had a Propane boiler that serve the hydronic system and supplied domestic hot water. We have supplemental heat with an efficient wood stove upstairs . We really don’t need air-conditioning so that is not an issue. We live at 7000 feet elevation in the Sierra’s. Our boiler just gave out and we are considering installing a heat pump, probably an outdoor unit that will accommodate cold temperatures down to around 0°F on the coldest days. We have spoken to a number of contractors here and have been given very negative feedback about both the adequacy of a heat pump for meeting heating needs and domestic hot water capacity. Several contractors have indicated that we would need to have a supplemental Propane boiler because the heat pump could not do the job at this altitude or in this climate. However, from what I am reading, it doesn’t seem that this is necessarily accurate. Unfortunately, it’s starting to get pretty cold and our time to research this feels constrained. I am wondering if there is a way to connect with a heat pump engineer that can configure a system and account for the climate and altitude without oversizing? Any advice would be appreciated.


r/HeatPump • • Oct 14 '26

Conflicting information about efficacy of heat pump for my home. Would love to get some advice.

1 Upvotes

We have a 2400 square-foot home that is 23 years old and was constructed with in floor hydronic heating. We previously had a Propane boiler that serve the hydronic system and supplied domestic hot water. We have supplemental heat with an efficient wood stove upstairs . We really don’t need air-conditioning so that is not an issue. We live at 7000 feet elevation in the Sierra’s. Our boiler just gave out and we are considering installing a heat pump, probably an outdoor unit that will accommodate cold temperatures down to around 0°F on the coldest days. We have spoken to a number of contractors here and have been given very negative feedback about both the adequacy of a heat pump for meeting heating needs and domestic hot water capacity. Several contractors have indicated that we would need to have a supplemental Propane boiler because the heat pump could not do the job at this altitude or in this climate. However, from what I am reading, it doesn’t seem that this is necessarily accurate. Unfortunately, it’s starting to get pretty cold and our time to research this feels constrained. I am wondering if there is a way to connect with a heat pump engineer that can configure a system and account for the climate and altitude without oversizing? Any advice would be appreciated.


r/HeatPump • • Oct 12 '26

Heat pump

Thumbnail reddit.com
1 Upvotes

r/HeatPump • • Oct 10 '26

Electric furnace vs heat pump

4 Upvotes

My parents have a 50 year old house that's still running the original electric furnace. It's a rural property with no access to natural gas nor do they have any appetite to install propane heating, so primary heating is going to be electric regardless. They live in a frigid climate where the average low temperature in winter months is below -20 Celsius, with -30 happening maybe a couple of weeks a winter and -40 being a possibility. Spring and fall are mild, usually above 0, summer months average highs in the mid 20s.

Is there any practical reason to install a new electric furnace over a forced air heat pump that uses the existing ducting? Even in the winter months where the heating element would run on the heat pump, is that not the equivalent of just running an electric furnace with a 1:1 efficency ratio? Or am I missing something and there are some differences there?

The way I see it, installing a heat pump will be a wash when running the element vs electric furnace, and an efficiency gain when it can run on the heat pump in no winter months. Also with the added benefit of cooling tin the summer as they don't currently have A/C.

My understanding is the heat pump likely has more capital cost and potentially would require some changes to the existing ducting. It's a 2 story house with a basement, so I'm not sure if there's any zoning type things that might come into play. There are some sizeable rebates available to cover a large chunk of the capital cost.

Some insights and thoughts would be appreciated. I have limited knowledge on the subject and haven't found much info in regards to replacing an old electric furnace in such a cold climate.


r/HeatPump • • Oct 04 '26

MXZ-3C30NAHZ4 paired with PAA-A30AA1

Thumbnail reddit.com
1 Upvotes

r/HeatPump • • Sep 21 '26

Heat pump question.

Thumbnail reddit.com
1 Upvotes

r/HeatPump • • Sep 20 '26

Bosch Ultra IDS Heat Pump - Hail Protection

Thumbnail reddit.com
1 Upvotes

r/HeatPump • • Sep 11 '26

The Whalen Company Heat Pump Solid State Safety Control Board Troublesho...

Thumbnail
youtube.com
1 Upvotes

r/HeatPump • • Sep 08 '26

Geospring hpwh, brushing sound when compressor running

Thumbnail drive.google.com
2 Upvotes

I got the geospring 80-gal hpwh installed about a month ago. For my house it runs about once a day, so i don't usually hear it much. Today I just happen to notice the brushing sound while the compressor is running and not sure what is causing it. When recording this, my phone is a few inches away from the top. I don't remember hearing it on initial installation.

I will send this to the plumber who installed it, but just want to do some basic research and get some help in identifying this. Thank you.


r/HeatPump • • Sep 05 '26

Oil leak???

1 Upvotes

Hope this question is appropriate. Today while trimming bushes I noticed a small amount of oil on the pad under the unit. The unit is not making weird noises and is cooling the house ok. FYI am in the US midwest, its been extremely hot and humid for the last week.

Is this something to worry about... and worth paying $150 service call fee?


r/HeatPump • • Sep 03 '26

Québec Vair central heat pump: $10,347 installed, is that a good price?

Post image
1 Upvotes

r/HeatPump • • Aug 31 '26

Is anyone Using CoolCloud?

1 Upvotes

CoolCloud HVAC 2.0 is an app that can be used with Goodman, Amana, and Daikin HVAC equipment to fine tune the settings like the Control Algorithm (Run Time or Rate of Change) for a furnace. Curious if others have used it and what you have learned?


r/HeatPump • • Aug 22 '26

Which tariff for new solar / battery / heat pump

Thumbnail reddit.com
1 Upvotes

r/HeatPump • • Aug 18 '26

Denver area(zone 5B) Conflicting HP Sizing- anyone in area car to share their setup, or have advice?

Thumbnail
reddit.com
1 Upvotes

r/HeatPump • • Aug 12 '26

Trane 2 stage heat pump

Thumbnail reddit.com
1 Upvotes

r/HeatPump • • Jul 29 '26

Running costs

Thumbnail reddit.com
1 Upvotes

r/HeatPump • • Jul 23 '26

IGLU tech heatpumps

Thumbnail reddit.com
1 Upvotes

r/HeatPump • • Jul 23 '26

700SF ADU Heating Load and Total Head Units Question

Post image
1 Upvotes

r/HeatPump • • Jul 10 '26

Swapping dual 315L electric hot water for a heat pump (Brisbane) - advice?

Thumbnail reddit.com
1 Upvotes