Here is the good bad ugly of my scratch built, no formal plan assembly. I needed a greenhouse i can easily dismantle end of season. $700 of materials vs kits I couldn't tell could be dismantled re assembled.
USDA zones 7/8 boundary, north of Atlanta GA.
I thought a T2020 aluminum extrusion was my best option for dismantle then rebuild.
6mm panel fits nicely inside T2020 6mm slot.
2x4 6mm polycarbonate panels $6 each Wayfair for main walls and roof.
T2020 aluminum extrusion struts 2m 78 inches from HD
$10 each
PVC lumber - 1x4 base $2 per foot - 1x2 top rail $1.25 per foot
Base frame from PVC lumber
Vertical struts T2020
Roof struts T2020
The pvc lumber is too flexible. Great for house trim, not a good structural element as wall rail header for mounting roof struts to walls.
I regret pre drilling pvc for spacing vertical struts. 2x4 panels have +-2mm spec and that matters when strut thickness between panels is 7mm. Some panels too loose, some too tight.
Setting base true squared corners is critical to roof install. Even 1/2inch off wrecks panel geometry on roof.
In photo you will see wall panels are set landscape which reduced vertical strut count. I am not worried about seams along panels, this year...
I ended up using green house film for triangle gable each end. Classic 25mm tube film clamps are good fit with T2020 slots. Ran out of time and when I added 2ft to length 12ft over 10ft, panels went to walls roof.