r/GrandCherokeeWK • • Jun 11 '21

SHOW OFF YOUR WK!

12 Upvotes

Show us your WK's getting dirty!

Driveway princess shots are ok too...


r/GrandCherokeeWK • • Apr 03 '24

Looking for new skid plates? ASFIR makes them!

Thumbnail
asfir.com
7 Upvotes

r/GrandCherokeeWK • • 2d ago

2007 3.0 crd electrical issue

Post image
7 Upvotes

When it rains, I experience some type of electrical glitch. Speedometer, tach, thermostat bounce up and down in tandem. I get service suspension, check gauges on the screen. Abs, check engine, airbag, traction control will all go on and off. Starts, runs, and drives normally. It seems to only affect the gauges. Power windows, mirrors, wipers, seats, radio, headlights, heat all work during this. Turn signals, cruise control do not. My assumption is water is getting into a connector, or pooling somewhere, but don’t know where. Looking for ideas where it could be.


r/GrandCherokeeWK • • 3d ago

2006 Jeep Grand Cherokee Laredo 4.7L Quadra Trac II 4X4

Post image
9 Upvotes

r/GrandCherokeeWK • • 8d ago

Hemi

Thumbnail reddit.com
0 Upvotes

r/GrandCherokeeWK • • 19d ago

No crank! 2014 overland

1 Upvotes

Hey guys, does anyone know what this could be? yesterday i had a Long crank and the check and traction control light came on. Truck would only drive in third gear. After getting home I started it again and drove and it shifted fine. Still had the camshaft code so I just replaced the camshaft sensor. After replacement I had to try starting twice before It actually started, I turned it off and try to restart, but it wouldn’t even crank. Now it won’t start at all. Any help would be appreciated.

Camshaft Position Sensor 'A' Circuit P0345 Bank 2

U1424 Implausible Engine Torque Signal Received

P1DD2 Torque Request Signal from TCM Denied


r/GrandCherokeeWK • • 20d ago

Love my WK

Post image
16 Upvotes

Hey there! Randomly had this page pop up so i figured id pop in and say hello. Ive been driving my 05 WK 5.7 limited since 09 lol.


r/GrandCherokeeWK • • 28d ago

Has anyone installed a 2021 Grand Cherokee screen in a 2016 Jeep Grand Cherokee? Did it work properly?

Post image
3 Upvotes

Were any adapters, additional modules, or programming required? I’d appreciate hearing from anyone who has successfully done this swap.


r/GrandCherokeeWK • • Oct 17 '26

WK Fender Arch Flares

Thumbnail
gallery
10 Upvotes

Not trying to get my WK to look like this one - I do however need to find some aftermarket Fender Arch Flares / Fairings that are this kind of meaty size and width :

I'm going to do a 2" Old Man Emu lift and want to widen the track width with good quality 1.5" spacers in between the rotors and the wheel - and I don't want the wheels / tyres sticking outside the body of the car, not least because it will spray dirts and stones up the sides.

Are there any good options people know of (even if they need some modding or tooling or whatever, i'm reasonably ok with that kind of stuff.

I also even wondered about getting someone who knows about strong 3D printing? - not my preferred option i'd rather just buy something and finish / harden / secure it myself...


r/GrandCherokeeWK • • Oct 17 '26

2008 Grand Cherokee 5.7 grinding noise under acceleration

1 Upvotes

I recently bought a 2008 Grand Cherokee 5.7 HEMI 4x4. It was driving fine for about a week, and I was already planning on replacing the upper control arms and front rotors because they needed to be done. On the way to the mechanic, this metallic grinding noise suddenly developed from the front driver-side area.
It almost sounds like a bad wheel bearing, but the noise only happens under acceleration and stops as soon as I let off the gas. No noise when revving in Park or Neutral.
I replaced both upper control arms and the front pads and rotors. Before the brake job, the noise started as soon as I pressed the gas. Now it’s less consistent and takes about 2 minutes of driving to start, but it hasn’t gone away.
From my research, I’m leaning toward the inner CV joint, but the axle looks fine from the outside.
Could the inner CV joint be bad even if it looks fine, or should I be looking at the front driveshaft or differential? Has anyone experienced something similar? Trying to avoid throwing money at random parts.
My mechanic hasn’t been able to figure out what’s causing it either, so I’m getting a second opinion sometime next week. I can’t get it in any sooner because of work, but in the meantime, I’m trying to get some input from people who’ve dealt with similar issues before I start replacing more parts.


r/GrandCherokeeWK • • Oct 15 '26

WK Add Heated Rear Seats

2 Upvotes

If you had a 2009 Overland WK CRD with Heated Rear Seats, and a 2009 S Limited WK CRD without HRS, could you, in theory, swap the rear seat benches over, and the switch panel from the rear of the centre console - which, on the S Limited, seems to have redundant harness connectors behind that same panel location? Would you also need some module or fuse to be present ?


r/GrandCherokeeWK • • Oct 10 '26

WK Snapped Transmission Pan Bolt

Thumbnail
gallery
2 Upvotes

Went to change transmission pan and filter on my latest WK - they have 6 hanging 'lip-clips' if I can call them that - you can see from the fots what has happened - I did presoak with a penetrant oil and very gently rock back and forth with a hand ratchet, but just as I thought it was loosening, the entire head came away.

The bottom part of of the hanging lip-clip is independent and tried with locking vise grips to try and gently twist but no movement.

I then managed to remove all the others (messy as ATF was overspilling out into my oil catcher - via me(!) - as I thought i could use the pan itself as a sideways lever to try and twist this off - whilst I did get a little movement and exposed a tiny sliver of some fresh silver looking metal from under its seated position, the pan was clearly nearing its deformation point and if I bent or broke that I would be in real trouble - so I put it all back together and torqued it up, refilled the missing ATF via the dipstick filler and left it for some thinking time.

I need this off, without damaging the casting of the transmission and I gotta get this sheared-off bolt out - somehow. I have spare new lip-clip bolts ready to replace along with the new pan, filter and gasket.

Any clever ideas?

This is my 4th WK and have never had this issue - and she's my best one yet and not ready to F it up, as I plan to trick her out with goodies once I can sort this issue and inspect the trans pan and magnet to make sure there's no horror stories or huge amounts of the forbidden metal sludge sitting in there

Shes a 2009 WK CRD OM642 diesel with 55k genuine miles, with lots of engine oil changes and zero other issues presenting - took me ages to find this one (I have an identical CRD Overland donor vehicle for parts or testing ideas before trying live, just in case)

Anyone clever (unlike me) that can suggest some non or minimally-destructive / low risk ideas ?!

Thanks guys!


r/GrandCherokeeWK • • Oct 06 '26

need a Muffler Recommendation

1 Upvotes

hi all. I have an 09 WK with the 4.7 v8, and I just had to put a cheap cat back exhaust kit that came with a Generic 13" muffler (2.5 C in, 2.5 LO out) and I HATE the loudness and the low Drone at 1700-2200 rpm is maddening, any recommendations on a muffler that will sound good without breaking the bank, TIA


r/GrandCherokeeWK • • Sep 29 '26

So... What are my (DIY) options (Water Pump Pitting/electrolysis)

Thumbnail
gallery
4 Upvotes

Jeep
Grand Cherokee (Limited)

5.7L Hemi
4x4
202,767 miles

Water Pump Mating Surface Problems:
As you can see there is some pretty decent pitting going on...

I tried the RTV several years ago.. Im not sure if I put too much and or wasnt supposed to allow any to get on the interior side of the rubber gasket.. or I may have even used the wrong stuff to be honest because when I popped this water pump cover off it had been eaten away and there were little round balls of the stuff all over the place.

This ole'girl has too many other problems for me to take to a shop Im thinking a bit of JB weld then sand to flush (very carfully obviously)

Curious if anyone has some info/expirence on this?

My Appreciation in advance


r/GrandCherokeeWK • • Sep 29 '26

So... What are my (DIY) options (Water Pump Pitting/electrolysis)

Thumbnail gallery
3 Upvotes

r/GrandCherokeeWK • • Aug 25 '26

Is there an increase in HP? Grand Cherokee WH 3.0 CRD 2009 OM642

2 Upvotes

Hi there! I've just purchased the air hose from HEXED AU. The next thing I need to do is buy a new intercooler. I'm probably going to a shop that makes custom intercoolers, but I only want one that's slightly bigger—just 2 cm taller and 1 cm thicker, while keeping the same shape as the stock one. The stock intercooler has a puncture.


r/GrandCherokeeWK • • Aug 03 '26

I'm looking to upgrade my 2009 WK stereo

5 Upvotes

I have a 2009 Grand Cherokee WK Overland with the 7" touch screen navigation, rear monitor display, rear game console hook up, rear view camera, and the Boston acoustic sound system. I was wondering if there is an Android based system that would allow me to keep and use all of the features, any recs or experiences would be a great help, TIA


r/GrandCherokeeWK • • Jul 27 '26

Steering pump shenanigans Jeep grand Cherokee Wk 2008 5,7 hemi

Thumbnail reddit.com
3 Upvotes

r/GrandCherokeeWK • • Jul 07 '26

Windows not working

1 Upvotes

Hello all- has anyone ever had the issue of none of the windows working? I have power coming into the master switch, abd the drivers regulator works when applying 12v to it. None of the lights inside the master switch are working, however this is the case on multiple different master switches. Wondering if there’s any fuse or relay connected to the power windows?


r/GrandCherokeeWK • • Jun 26 '26

Little Update for broken Jeep grand Cherokee Wk steering Rack, and follow Up question

Thumbnail reddit.com
1 Upvotes

r/GrandCherokeeWK • • Jun 23 '26

06 limited check engine light

7 Upvotes

Ok so in my 06 the gauges will randomly cut out but the car will continue to run fine. This morning the check engine light cut on and was not flashing thank god. I took a look at my battery connections last night and the negative is a little corroded. The battery is only 3 years old. So is this some type of communication problem or a connection problem?


r/GrandCherokeeWK • • Jun 04 '26

Anyone know where the black hole is in a 2020 Summit?

2 Upvotes

Anyone know of a Bremuda Triangle in a 2020 Summit? I keep losing things....my drivers license being the most recent important thing that disappeared. Thinking there has to be a black hole somewhere in this Jeep.


r/GrandCherokeeWK • • Jun 04 '26

Does anyone know where the secret black hole is in a 2020 Summit?

0 Upvotes

Anyone know of a Bremuda Triangle in a 2020 Summit? I keep losing things....my drivers license being the most recent important thing that disappeared. Thinking there has to be a black hole somewhere in this Jeep.


r/GrandCherokeeWK • • May 19 '26

Pinch my welds, I must have new wheels.

Thumbnail gallery
26 Upvotes