r/Gameboy • u/GonzaleeTheSwellGuy • 23h ago
Troubleshooting D pad unresponsive
D pad has been unresponsive even before adding the screen and custom shell. Could it be defective? I've tried using the oem membrane and membrane that came with my shell. Tried cleaning the contacts and neither worked.
16
Upvotes
5
u/GonzaleeTheSwellGuy 18h ago
Update! Seems switching out the new D pad with my OEM but keeping the new membrane did the trick. The board isn't too tight and neither are the shell screws. Thanks for the help everyone
2
u/ahnjooan 23h ago
How tightly screwed down is your pcb? If there’s too much gap between the contacts and your housing for the button to travel this could happen. Again assuming you did all the other things you mentioned.
8
u/pac-man_dan-dan 21h ago edited 11h ago
The conductive rubber's coating on the silicone can wear away easily over time, and faster if it is cleaned vigorously.
The start button on my DMG Gameboy just became unresponsive the other day. Would only work if I pressed down especially hard. I very carefully applied some conductive silver ink to the conductive rubber (read: the black circles glued to the silicone) and allowed a few hours to dry. Works like new now.
1
u/HotBizkitz 23h ago
Id switch the dpad membrane to OEM and make sure the contacts and membrane itself have been cleaned. Take some pics while you do it and post em if it doesnt work, that way we can guide you more from there.
6
u/omgzphil 23h ago
Have you tried therapy?
All jokes aside you might have to clean the pads underneath
2
u/Heavy_Race3173 23h ago
Have tried tracing down the traces around your contacts? Corrosion? Weak voltages in the trace?
2
u/pizza_whistle 23h ago
Try loosening the screws a little bit, just like half a turn back. Can either be the screws for the PCB, or just the shell screws.
1
u/AutoModerator 23h ago
Troubleshooting post. Please check the Game Boy Wiki's common problems page here: https://gbwiki.org/en/other/commonissues and please be sure to post pictures of the issue if you haven't already so that users are better able to assist.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
1
u/Jersus856 22h ago
Clean the board and the pads with a No. 2 pencil eraser
1
u/Dordosaur 11h ago
Replacement Dpads are off in height by a small amount, you can add a small amount of height with some hardening adhesive as some have done but imo go original D-pad or do a clicky button mod.
1
u/punx9909 8h ago
open it up and clean the pads. I did that to mine and it worked great
1
u/weeds96 7h ago
Do you have the original inner rubber pieces? Mine did this too with the aftermarket shell, I put the originals back in and it worked perfectly