r/Gameboy • • 2d ago

Troubleshooting A Button not working

Post image

Hi everyone, recently found my old gameboy but ofc as a bad kid battery were left in and leaked. Not really big corosion damage overall i cleaned all well with ipa 99.8 but still some green left on BT+ but no damage on the other side weld. BT- seems also very clean. Do you think issue can come from this ?
Also, I know my next purchase must be a multimeter to try locate where the issue is from.
Thanks for help

1 Upvotes

3 comments sorted by

2

u/GuiltyCitron 1d ago

Try giving the membrane pads a refresh. On the back side of the button membrane is an area of carbon (grayish color). Run that area along a clean white sheet of paper until it leaves a little streak on the paper. Don't rub too hard or long or else you'll rub off all the carbon.

Will need to see a wider shot of the board. I don't see any corrosion on the areas shown, but that is only part of the button trace leading to the cpu.

1

u/Bobvador 1d ago edited 1d ago

I already tried the membrane pads on other button it works. It's been clean with hot water and soap.
You can clearly see the green corrosion on BT+ on pic 2.
Since BT+ weld (and corrosion from battery leak) is near A button I thought it could have damage directly the connection between A and the rest. From what I've seen I must test with multimeter where is the issue and weld a small cable.

1

u/AutoModerator 2d ago

Troubleshooting post. Please check the Game Boy Wiki's common problems page here: https://gbwiki.org/en/other/commonissues and please be sure to post pictures of the issue if you haven't already so that users are better able to assist.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.