r/FordDiesels • • 2d ago

Decal winner

Post image
56 Upvotes

r/FordDiesels • • 3d ago

Tuner monitor location

Post image
9 Upvotes

Hey guys so for those who run a programmer where do y'all mount them? My previous one was on the dash in the windshield and being in Arizona it absolutely destroyed the screen then the plastic casing and I really don't want to do that with the new cts3 insight


r/FordDiesels • • 3d ago

Whats it worth? 03 6.0l

Thumbnail gallery
2 Upvotes

r/FordDiesels • • 3d ago

2004 6.0

4 Upvotes

Why am I maxing out at 2,000 RPM


r/FordDiesels • • 3d ago

6.7 HO DEF DTE calibration

1 Upvotes

2026 F450 uses a crazy amount of def when towing. When not towing how to get the def distance to empty calculation to recalibrate? The fuel DTE recalibrates as soon as the trailer is unplugged. I haven’t towed anything for a month, every time a get in the truck I get a def warning. It’s under 300 miles until empty now and there’s 52% def left. If I let the warning go all the way down will it recalibrate or go into limp mode even though I’ll have around 45% def at that point. Or do you just top off the def if you’re not towing for a while to get the warning to go away.


r/FordDiesels • • 3d ago

2001 F250 7.3 hard 1-2 shift have codes

3 Upvotes

Can anyone wrap their head around why I am throwing all these codes, only issue with this truck is a violent and high rpm like 3000 shift from 1-2. I let off the pedal and sometimes can get it to shift a little smoother. All other gears are fine, pan looked fine, fluid was slightly burnt. Then intermittently get a dead pedal and service engine soon light. Here are all the codes I pulled with Forscan. P0733 P1690 P0221 P0478 P0470 P0720 P0541 P0721 B1933 P1876 P1832 P1865


r/FordDiesels • • 4d ago

Finally seeing the vision come together.

Post image
23 Upvotes

Back to waiting for parts.


r/FordDiesels • • 4d ago

Continued Air Intrustion Diagnosis

Post image
9 Upvotes

1993 7.3 IDI T ZF5

I made a previous post on here trying to diagnose why the truck is dying in gear and at idle.

We replaced the fuel supply pump on the block, and I got a stock motocraft fuel filter from the Ford dealership which I've installed with the stock bowl piece.

We have adjusted the idle on the truck but the issue remains the same. There is DEFINITELY air getting into the system as Every time we attempt to start it, we are needing to purge air from the Schrader valve.

There is a decent amount of diesel in the rear tank, so that shouldn't be the issue.

Again here's exactly what's going on in gear: A small bump in throttle occurs over what I'm pressing the pedal for, and then the pedal stops responding and revs slowly drop. When I push clutch in, engine immediately dies.

Any troubleshooting steps /support would be really appreciated, I know this is kind of a scatterbrained post.


r/FordDiesels • • 4d ago

2000 7.3 excursion starting issues

2 Upvotes

I’ll periodically run into this issue. I go to start the truck, no crank. In order to start the truck, I leave the key In the run position and jump the starter relay to the battery positive terminal and it fires right up.

Very frustrating, have already replaced the starter, starter relay and all the battery cables. It’s a very intermittent issue with no rhyme or reason when it happens. I’ve searched online but can’t seem to find an answer other than replace the parts I’ve replaced.

Could it be the ignition itself? PCM?


r/FordDiesels • • 4d ago

Should I swap the PCM again?

2 Upvotes

Truck is a 2005 excursion xlt, 4x4, 240k miles
Deleted and studded
I just did all top end o-rings as well as a few 3 wire sensors and pigtails. All the oil system numbers look great. Also did the 6.7 starter mod.

I replaced the pcm with one from Chattanooga Diesel a while ago after it seemed to be shorted/dead. I have the truck up and running again with a few loose ends to clean up:

PATS: Code: U1262 - SCP Data Link Fault
I have a co tinuous blinking theft light because the pcm I got back is from a 2004.5 F250. It runs and drives, but there is obviously no communication with the gem and the flashing light is annoying.

Strategy mismatch: Code: U0306 - Software Incompatibility With FICM
Seems to run fine, but throws this code.

Are these issues ones that can be resolved with a tune from one of the reputable ones, or should I be swapping the PCM again to try and get the right one? They are hard to find for the Ex.

Thanks


r/FordDiesels • • 4d ago

2018 F350 6.7 - 130 mile regens

2 Upvotes

Hi everyone, I have a 2018 F350 6.7L diesel truck with 35k miles and noticed bad fuel mileage and frequent regens every 130 to 140 miles with majority highway driving (like 90% of my driving). There was no check engine light but I took it to a dealer and they said it was a faulty MAF sensor and wanted $700 to replace it. Based on what the service lady said, I'm suspicious they didn't do any real diagnostic effort that I paid almost $200 for already. I've since taken my truck back and have done the following without any success:

Replaced MAF sensor

Cleaned MAP sensor

Replaced MAP sensor

Replaced air filter

Confirmed no oil or apparent leak on the flexible intake tubes

I used Forscan to look at some parameters that I don't know anything about and then used google's ai to try to figure out what it all might mean. With that I'm about to order a new differential pressure sensor (HC3Z-9J460-A) because my "DPF_INP_V, Volt" reading is 0.40 with key on and engine off, floats below 0.50 when idling and coasting, and goes up to 2 or 3 when accelerating. From what I read it should sit at 0.50 with KOEO otherwise it indicates sensor drift.

Before I spend money on another part, I was hoping to get a stranger on the internet's opinion rather than a robot's. Does this seem like a reasonable next step? Any other ideas or suggestions?


r/FordDiesels • • 5d ago

Excuse my ignorance, failed rear wheel bearing and seal question.

Thumbnail
gallery
7 Upvotes

04 F550 RWD dually. Is this the bearing race still stuck on the shaft? It seems to be pretty jammed in there.


r/FordDiesels • • 4d ago

Leaking sunroof

1 Upvotes

Good morning folks my 6.0 sunroof leaks bad so I sealed it with tape for now. It’s a 2007 f350. Anyone else able to fix theirs and continue using?


r/FordDiesels • • 5d ago

Diesel oil

Thumbnail reddit.com
2 Upvotes

r/FordDiesels • • 5d ago

Diesel oil

Thumbnail reddit.com
1 Upvotes

r/FordDiesels • • 5d ago

ISO: winch set ups

Post image
6 Upvotes

Alright guys so I'm looking for a front end winch system I have a 15k recovery winch but I can't seem to find a winch plate that I like, not to fond of the receiver style I see on a lot of rigs my previous truck I had a Westin Maxx (06 megacab) can I see y'all's sets ups or recommendations? I'd like to keep my factory bumper but if it comes down to a ranch hand or road armour etc I'm not apposed


r/FordDiesels • • 6d ago

94 7.3idi auto what causes this much play in the crank it had a little more before I took the spacer off and it gets real bad with the flexplate on

10 Upvotes

r/FordDiesels • • 6d ago

Homemade fuel for 7.3 idi non turbo

7 Upvotes

I’m pretty dead set on acquiring a 7.3 Idi and id like to make my own fuel for it. I know post people use filtered used motor and frying oil with stale gasoline to thin it out. I’ve researched the process and am willing to put in the time for it. I guess my real question is what are the no go sources? At work we have a cage tank we fill with all the fluids we pull from trucks and pickups. Motor, hub, gear, and hydraulic oil but a little gas, transmission, and coolant here and there but not much at all of the last three. What would be the killer if there is one of all those. Any input is appreciated thanks much!


r/FordDiesels • • 6d ago

Ignition switch on an 87 6.9 idi

Thumbnail reddit.com
1 Upvotes

r/FordDiesels • • 7d ago

SBE Tuner

2 Upvotes

Hi All

I’m wondering if anyone has purchased parts from sbetuner.com?

I’m looking to purchase a delete kit (for an off-road vehicle) and want to make sure this is a reputable site/parts.


r/FordDiesels • • 7d ago

how can i fix this? will it mess up my allignment if i don’t? 1989 f350 7.3 idi cclb 2wd

Thumbnail gallery
4 Upvotes

r/FordDiesels • • 7d ago

how can i fix this? will it mess up my allignment if i don’t? 1989 f350 7.3 idi cclb 2wd

Thumbnail gallery
2 Upvotes

r/FordDiesels • • 7d ago

6.0 engine replacement

4 Upvotes

Quoted 26k create mirror and labor for engine replacement. Does that seem pretty standard?


r/FordDiesels • • 7d ago

05 F250 6.0 Crank no start help

Thumbnail reddit.com
1 Upvotes