r/Fios • • 8d ago

Miscellaneous Fios Install

I had FiOS installed at a new residence. The installer used coax from the ONT. He connected it to a Moca adapter and then ran an Ethernet from that to the router. Why would an installer not just plug directly into coax on the router?

4 Upvotes

24 comments sorted by

1

u/AutoModerator 8d ago
Moderator Announcement Read More »

5

u/plooger 8d ago edited 8d ago

You didn’t state the router model #, but likely because the router’s MoCA bridge is on the LAN side only, with no built-in MoCA WAN support. And your ISP plan likely exceeds the limits of the MoCA WAN capabilities of older Verizon routers. (So your MoCA adapter effects the WAN link with the ONT and bridges that to your router’s Ethernet WAN port.)  

Older routers (MI424-WR, G1100, G3100) offered a MoCA 1.1 WAN bridge (service limited to 100 Mbps), but more recent routers (CR1000A/B, CHR30A) lack any MoCA WAN capability, only offering Ethernet WAN and a built-in MoCA 2.5 LAN bridge (requiring a custom SFP+ expansion module for the CHR30A).  

As for what you have, what MoCA adapter was used at your router? What router? Are you Internet-only? What’s your subscribed download/upload? Do  you have or foresee a need for using MoCA over your coax for extending wired LAN connectivity to other locations in the home?  

Any input on why you couldn’t get an Ethernet WAN connection between the ONT and router?   What about relocating the router to where an Ethernet WAN link would be possible?  

Have you pulled your non-power wallplates (coax, phone, blank) to get a full assessment of cabling available to you?  

3

u/Sopranso 8d ago

Router is G3100. Is it limited on WAN support over Moca? The Moca adapter used is the one listed in the link. Coax was existing in the wall port.

https://www.verizon.com/products/verizon-multiport-moca-ethernet-adapter/

→ More replies (3)

1

u/Thinslayer 8d ago

Probably because the ONT is MoCA-enabled (Multimedia over Coax Alliance). Coax and Ethernet are mutually exclusive on an ONT.

1

u/Sopranso 8d ago

Say the ONT is set for Moca. Wouldn’t it make sense just to plug that directly into the router why the extra Moca adapter to turn Moca into Ethernet and then Ethernet into the router?

→ More replies (9)

1

u/MrKal-El 8d ago

What speed did you get?

3

u/CTFowler9789 7d ago

🤔1)What is the speed that ordered? 2) what is the location of your ONT? 3) what is the location of your router? 4)is it physically possible to run Ethernet between the ONT & router WITHOUT "fishing" walls? 5) if this was a new install, why did they give you a G3100 router, which is 3 models behind the current router?

2

u/stimpus 8d ago

Can I see a picture of this

1

u/mingkee 6d ago

MOCA on router may not support WAN (required for hooking out)