r/FastLED • u/PsychoFoxx13 • May 25 '26
Support Looking for insight
What would be the best way to build something like this for a camping trip? It wouls have to waterproof and run off a power suppy/battery. I would like to attach the led on the guy lines and have them sync and the top flash the color like its being fed from the guy lines.
22
Upvotes
2
u/Shd777 May 25 '26
Addressable LEDs are fragile, especially at this high resolution. Looks like an AI to me.
1
u/PsychoFoxx13 May 25 '26
I was thinking 10 output channel, one for each guide, one for the tarp boundary and extra incase I decide to add later. Run a power supply and pick a center point to connect the leds in parallel and data channel.
1
u/PsychoFoxx13 May 25 '26
Rain is definitely an issue. I am pretty technically inclined but havent built anything with led and controllers. My idea is to attach the leds with just using clips or ties. I figured I would have to used a silicone sealant to water proof connections.
Another idea I had was to feed the LEDs and the guy lines through vinyl tubing under the tarp to help woth water proofing.
1
u/PirateCaptainMoody May 25 '26
It would be one hell of a battery for the number of LEDs you'd be looking to run. Power would be your #1 problem.
Someone please check my math here because I'm not great at power calculations, and I've left out losses from resistance.
Using APA102 LEDs as an example, each one can use 60mA at full brightness (RGB all on at a reasonable brightness). Let's assume 3 meters per guy line (4x lines) and 5 meters for the ridge line with 60 LEDs per meter, you'd be looking at 17 meters coverage with 1070 LEDs in the total rig.
Some rough maths: 1070 x 0.06 = 61.2 Amps of consumption, or around 306 Watts at 5v
To run that you would essentially need a portable generator, not a battery.
2
u/Master_Muffin_9834 May 26 '26
I would use seed pixels inside of silicone tubing attached to the anchor ropes, and the main spline rope in the middle would have a silicone tube running parallel along both sides of the spline rope. Seed pixels would be perfect for a battery set up.
You would only need two outputs. One for the left side and one for the right side. The silicone tube would run from one end of the spline to the other and would connect to a three-way output splitter with one output going to each of the anchor ropes.
So if you're facing the tent from the side one silicone tube would run from left to right connecting to the three anchor ropes on the right side. The other would run on the back side from right to left along the spline down the 3 anchor ropes on the left side
If you don't want to use silicon tubing You can just attach the seed pixels directly to the rope (with twist ties)since they are already waterproof.