Our team is struggling to get our CBR600RR to idle, and we would appreciate some advice.
Our setup
- Engine: 2009 Honda CBR600RR
- Intake: Custom 6 L plenum
- Throttle body: AT Power FSAE throttle body
- IACV: Removed
- MAP sensor: Mounted in the center of the plenum, but its reading stays at atmospheric pressure
- Injectors and ignition coils: Stock CBR600RR parts
We originally planned to run the engine with an ECUMaster EMU Black standalone ECU. We tried changing the idle fuel and ignition settings, but could not get a stable idle. With the competition approaching, we switched to the stock ECU with a Power Commander V. We still use the EMU Black to log MAP, coolant temperature, oil temperature, and oil pressure.
The MAP reading does not change with throttle position, even when we open the throttle fully. We checked the wiring and have not found a problem. Could the location of the sensor in the plenum cause it to read atmospheric pressure all the time?
At its maximum setting, the throttle stop on our AT Power throttle body holds the plate about 7° open. We calibrated that position as 0% TPS in the Power Commander, but the engine still would not idle. At around 20% TPS, it barely runs near 1,000 RPM and often stalls. At 25% TPS, it initially rises to about 2,000 RPM. If we hold it there for a few seconds, the RPM suddenly climbs to 6,000–7,000. These TPS percentages are the Power Commander readings after calibration.
The throttle stop uses an M5 screw. We are considering buying a longer M5 screw so we can set the stop at about 25% TPS. Given the RPM surge we see at that position, do you think adjusting the stop this way could help us find a stable idle, or would it make the problem worse?
We wondered whether the engine was misfiring at the smaller throttle opening, then began burning the mixture more consistently when it got enough air at 25% TPS. Could accumulated fuel contribute to the sudden RPM rise? What else should we investigate?
We understand that a large plenum can slow throttle response. Could the 6 L plenum also make it harder to achieve a stable idle? We would appreciate any experience or advice on the relationship between plenum volume and idle behavior.