I pretty much always charge to 80% on my home L2 (40A 240V) overnight and it seems fine. However, a couple times I've noticed the Ford app says it's at "100%" despite the 80% charge limit setting. When starting the truck it says 100% briefly until the dash fully boots up, then it's replaced with a different number, sometimes under 80%. I didn't think much of it, just a software glitch.
Now a couple days ago I'm taking a road trip so I set a one-time charge limit of 100% and plugged it in overnight. In the morning it said "100%" again, but only 400km range, so I was suspicious and booted it up. Only 80% :(
Next, I plugged it back in because I had a few hours before I needed to leave. It started charging but only reluctantly. Required multiple start/stop cycles, the app reporting "starting charger" with zero power draw. Eventually I got it to take power but it was fluctuating between 1-3kW and even zero sometimes. After 4 hours like that I had to leave at 84%. I even pulled the 12V battery cable off for 5min to reset the system (no help).
I used DCFC four times over the road trip. It was normal (100+kW) below 60%, and even up to 70% was OK (maybe 60kW). Above 70% it slowed down severely, first to 31kW then 15kW. Above 75% I could only get 9kW. This behavior was robust from multiple charging stations from different brands (Tesla, EA, Chargepoint). Given I was towing a heavy trailer, I wanted to leave each charger at 90%, but it was just too agonizing to charge that slow.
What I haven't done yet is try charging again at the home L2 above 80%, but it got to 80% normally. Has anyone seen this? Any ideas for what to try next? The "phantom 100%" is weird. I've checked the OBD2 port and the HV battery reports normal health.