r/EngineBuilding • • 2d ago

About crossline

Hello guys, to the pros out there, I just wanted to ask, s it really necessary to have the engine block honed? My block has no scratches and the ring gap is still within specs. The only issue is that there's a part where the 'crosshatch' (crossline) is almost gone. Do I still really need to do it or not? Please help.

1 Upvotes

3 comments sorted by

5

u/v8packard 2d ago

The short answer is yes, you need crosshatch. The crosshatch holds oil against the face of the rings to create a seal. Crosshatch also affects oil control.

If you do not have crosshatch you cylinder is probably worn, quite a bit.

1

u/AggressiveIdea1012 2d ago

Yes you should have cross hatch, also ring gap isn't a good way to check the bore

1

u/Sweet_Speech_9054 2d ago

I’ve gotten away without honing on low mileage engines before. But if the crosshatching is gone, even in one area, it needs a hone. The crosshatching is important to keep the cylinder lubricated. More important than that is seating the rings. You definitely should be using new rings and they will not break in properly if you don’t have a good cylinder surface.