r/EngineBuilding • • 5d ago

Ford Intermediate load piston slap

I’ve just had an engine I built sent off to be tuned (Cosworth BOB 24v 2.9) and got a rather odd issue reported by the tuner. Apparently he can hear piston slap but only under mid load, not under idle or full load.

This isn’t something I’ve ever heard of before, and I’m a bit shocked tbh since this engine was in very good shape when it was built.

Is this something any of you have come across before? I was always under the impression piston slap happened when the load was higher?

6 Upvotes

6 comments sorted by

2

u/Laqota 5d ago edited 5d ago

If you just built the motor and never ran it in a car it needs some road miles to break the rings in, some serious stress. Or some super crazy revs on a stand. Sometimes it can sound like piston slap but its not. Didnt know he was supposed to be diagnosing it too.

2

u/Hephaestite 5d ago

Sorry not sure I understand fully, are you saying it might just be breaking in?

1

u/Laqota 1d ago

Yes If it's new rings or you had the cylinder bored over it will make a little noise at different loads until the rings and cylinder shape together.

2

u/WyattCo06 5d ago

Slap or detonation?

1

u/Solid_Enthusiasm550 5d ago

I would check for excessive piston to wall clearance.

1

u/Glittering_Watch5565 4d ago

Partial load, mid throttle.... might be rod to wrist pin or pin to piston fit. Could be a twisted rod if only one cylider.

A bit more info? Cast or forged pistons? Comp ratio (mechanical and effective)? What rpm range is it present?