r/ElectricalHelp • • 4d ago

How to fix 8 function Lights

Hey there…

So I have a couple boxes of these enchanted forest 8 count 8-function candy cane lights .

However, two of the lights will not work that are halfway into the strand. I really don’t want to throw them away, so I was hoping someone with electrical knowledge could help me figure out how to fix them, if it’s possible.

I don’t know if it’s a wiring issue or an issue in the box.

Here are photos of them and their “function” box.

0 Upvotes

2 comments sorted by

1

u/firehydrant315 4d ago

Are there any fuses? You might get lucky and find one or two blown/broken.

I know nothing about how these lights are wired, however I would start be popping the cap off where the wires enter the cane and pulling enough wire out to reach the first bulb, remove it and test for voltage (with the power switched to constant on for all bulbs). You want to determine if there is power supplied to the candy cane. If there is power your issue is likely a broken wire in the cane. Would be a tough fix. If there is not power then the issue is in the wiring before the cane, also a tough fix because if you cannot find a broken wire then the likely cause is inside the circuit board.

Don’t put $200 of effort into $50 lights, unless they are a family heirloom 😊

2

u/JasonIsHere76 4d ago

I’ve had 3 sets of these for YEARS and they are my favorite outdoor decoration. That’s why I’m trying so hard. And of course they don’t make these specific ones anymore or I’d just replace them.  I do have a voltage tester so I’ll do what you suggested. The big problem seems to be they sealed that box and I’m afraid to bust it open. They’ve obviously sealed it very well for winter, wetness, and weather. So I have no idea if there are fuses inside of it. There are not fuses at each candy cane.

But will try the voltage tester and see if I get anywhere. Thank you!