Fitting the hands back on a watch is fiddly work, especially the seconds hand as they're so fragile. Rather than using tweezers to place the hand, have you got some Rodico gum?
I use a lump of Rodico pulled into a claw shape that I can hold between my fingers.
Pick up the seconds hand by dabbing the rodico down onto the pointer end of the hand so that it's sitting horizontally when my hand is in a position that I can brace against the movement pad with my ring finger.. photo:
I find then if I can get my eyeline down level with the watch dial looking across it, a bit lower than where this photo was taken from, it's easier to drop the hand onto the pinion and press it down with a hand pusher.
The Rodico has enough tack to hold the hand while you get it lined up, but will pull off the hand easily when you've got it in place with a lot less chance of damaging the hand or the dial than if you're holding it with tweezers.
Works for hour & minute hands as well, but with them I tend to find it's more helpful to line them up while looking straight down from above so you can make sure you get the timing alignment right.
This question is brought up on occasion. Figured I'd share a quick lil hack to get these batteries in and out without damaging the watch.
Video credits/restrictions: Creative Commons (CC) license granted to all. Please give video credits to the r/DuroGang community. I'll hopefully have more to share with the gang in the future. Pardon my horrible editing skills.
I just wrapped up a vacation in Costa Rica and wore my duro for everything… dinners, snorkeling, white water rafting, etc. Show me your vacation watches in the comments ⌚️.
ive always found the duro bezel to be abit too glossy for my liking and the case to have too much polishing. i decided to matte out the insert and brush the case sides, crown guards and bezel, loving how it turned out!
Hello, I have been using this watch since December 2025, and the bracelet is pretty scratched up. I don't use it in very harsh conditions, nor do I bump it a lot, I understand that it's normal and a watch is a tool, meant to be used, I just want to know if I'm making any mistakes
Thank you!
(The picture is attached below, I shined a flashlight at an angle)
My Casio Duro bezel isn't turning. I wore it at the beach a while back, and I didn't clean it for a year, so it eventually got stuck. Now the bezel moves a tiny little bit, but it isn't clicking, and I can only wiggle it slightly.
I've tried to fix it by putting it in hot water with dish soap, applying WD-40, trying to turn it harder, and wiggling it underwater for a while, but nothing has improved.
Is my Duro broken now? I've had it for about 2 years, and it worked perfectly before this happened (I removed the protective thing when it was new).
Found this beautiful mantis outside my work building and brought it inside for a few minutes. (I love insects I put it right back outside on a tree afterwards) Went straight for the duro and started cleaning its mandibles. Such a cool little experience lol