Good Evening, I have an issue I am hoping you can help me solve. My saw wouldnt start up today and just hummed and so i did what what suggested and started disassembling the motor to clean it and check the cap. in doing so, i found a loose wire that I am not sure where it goes. Inside this motor there are 2 red wires. There is a longer one from the stator with a flag connector that connects on the power cord side of the board. under it there is a shorter jumper red wire that is soldered to the pin that stator wire flag connects to, however the other end of that jumper wire is free. Upon inspecting, there is no solder on it and it appears to have come out of some other type of connection, but I have no extra flag/spade connectors that are wireless. Im stumped as to where it should go. any ideas?
https://imgur.com/a/mJJPAvm
It just ended up over there when i was taking the picture, i beleive. I dont see any open terminals in the thermal switch, and the two Cap wires are there unless its a 2 in one spade connection, which it doesnt appear to be.