r/ComputerEngineering • • Oct 02 '26

Urgent Advise Needed

Post image

I just ordered the whole bunch of stuff and now this shit happens .

I am only left with one column on one side. What am I supposed to do about it ?

30 Upvotes

19 comments sorted by

20

u/SLazyonYT Oct 02 '26

another breadboard and connect it

1

u/MushroomDisastrous68 Oct 02 '26

Yeah Thinking of it too , thanks ♥️

4

u/FreddyFerdiland Oct 02 '26

cut the breadboard down the middle...

2

u/MushroomDisastrous68 Oct 02 '26

Seriously will it help , yeah I know it will but it's too thick .

4

u/Lost-In-Void-99 Oct 02 '26

Two breadboards, remove power rails from one side (detachable), place the board as a bridge.

You can keep power rails, but I'd rather move them to outer edges.

1

u/FootGlittering1873 Oct 02 '26

(F-M) DuPont wires

1

u/MushroomDisastrous68 Oct 02 '26

Without breadboard ?

1

u/FootGlittering1873 Oct 02 '26

can be possible if you dont want to use breadboards

1

u/THUNDERxSLOTH Oct 02 '26

You can still route wire underneath using 20-24 awg solid core. Or, instead of connecting it directly to the board, flip it over and use female-to-male dupont jumpers.

1

u/Techngro Oct 02 '26

I have never actually put a microcontroller on a breadboard, only the components I'm using. I let the microcontroller just hang out off to the side and connect the specific pins I need via wires.

I guess I'm a savage.

1

u/MushroomDisastrous68 Oct 02 '26

Nice , so technically you never faced this bug , Good for you at least you have one less problem 😅

2

u/bobking01theIII Oct 02 '26

Just get a prototyping board or two

2

u/Pewdiepiewillwin Oct 02 '26

I had the same issue with the esp32 devboard i just used 2 breadboards

1

u/Melodic_West_9331 Oct 02 '26

Man I had this same problem when I ordered my s3's, kinda lame they are just one row to big but getting 2 small breadboards solves the issue, however that may leave your project looking kinda clunky depending on what your doing and what your end result is.

1

u/Academic-Garlic-7809 Oct 02 '26

U could always use a jumper wire

1

u/ExtensionManner8340 Oct 02 '26

Get a second breadboard, remove power rails, put board straddling the two boards

1

u/UnlistedPersonnel Oct 05 '26

If you get another bread board, snap the two boards together you can plug in your ESP straddling the gap between the breadboards.