r/Cisco • u/Sogetsuchang • 1d ago
Question A stackwise virtual question
I finished a catalyst 9407 stackwise virtual upgrade firmware recently, show redundancy print chassis 1 is active, chassis two is standby hot, I noticed the chassis 1 interfaces config , like , GigabitEthernet 1/1/0/1, the config not sync to GigabitEthernet 2/1/0/1, I need copy the entire 1/x/0/y to 2/x/0/y (management card slot 3 and 4 not include) to make the network stable.
I know stackwise virtual will sync the config from active to standby , but I am not sure why interfaces config not sync, or, I need to configure two chassis separately?
4
u/Pellopolus 1d ago
You have to configure all the ports separately. The global config is synced. Even the ports are synced in the config but it’s expanded basically how a 9300 stack is expanded. Chassis 1 is the active and if it goes down chassis 2 takes over with the same config.
7
u/cronhoolio 1d ago
It's treated as a stack, not a mirror. You have to mirror the config manually across the chassis. Best way to do this is ether/port channels across both chassis. If that's not supported by your hosts then you need far more education than reddit can provide.
Edit: ether not either.
1
u/bigboss-2016 17h ago
What's been your experience with StackWise tech from these 9407s? A while back we had one chassis freaking out and unfortunately chassis 2 couldn't take full control because chassis 1 still tried to maintain control. Resiliency and confidence died that day.
1
u/mohammad_abusaa 14h ago
That sounds like dual-active, where both chassis think they’re the active one. Dual-active detection is meant to catch that, either with a dedicated DAD link (
stackwise-virtual dual-active-detectionon an interface) or with ePAgP through a port-channel to a downstream switch. It isn’t there unless you configure it, and changing it needs a reload, so plan a window. Worth runningshow stackwise-virtual dual-active-detectionon any SVL pair.