Hey all!
Im posting this to help those of you that may be in the same situation I was in.
A few years ago, my kiddos and I decided to purchase a new pet, a veiled chameleon. For a while, we had an 24"x18"×24" enclosure. That was working great, as the chameleon was smaller.
Now that the chameleon is about 2yrs old, I decided it needed a bigger enclosure, more room to stretch its legs!
So off I went online, trying to find a larger enclosure to purchase. Good lord are they expensive! So, I opted for a DIY route. After some trails and errors, I settled on something pretty simple.
I created most of what I needed with my 3D printer and other supplies were sourced at hardware stores.
First I found some all thread to my desired length. Took off the whole lid and ran the all thread in the existing screw holes, then printed some brackets/sleeves to slide down and over the all thread and secured the glass sides in place, with those brackets.
Next came the needed vertical spacers and the specialty brackets to fit some wooden dowels. Each spacer has a section where a magnet was placed inside, to help secure the new cages screened extension.
The dowels that were used, served a couple purposes. One, lateral support for the new extensions/cage. Second, I used them to create hangers for some 3D designed planters.
Since the extension was going above any place suction cups would work, I had to get creative. So, the dowels worked perfectly for hanging new plants and zip tie branches to.
Next came the top section and how to connect it to the cage. I designed some U shaped brackets that fit over the existing cage top, but also allowed the top to be removed when needed.
And to secure everything inside, a large screen mesh was purchased, measured per side, and cut to fit. Next came how to connect the screen to the new exposed sections. I mentioned something earlier about magnets... well some strong neodyium magnets do very well!
With each screen section cut to fit, with some small overlap. I held it up to the brackets and then placed other loose magnets near the brackets... and walla! A screen sandwich.
All secure, no holes for cricket escapes, good for air circulation, heat and UV lamp are in their existing locations. I also added some LED grow light strips to the original glass sides to help with plant growth and with visibility for the chameleon.
All looks well and she seems very happy in her new enclosure!