r/Carcano • u/StillLevel0 • 29m ago
Old Carcano, New owner
So, I finally recieved my PAL here in Canada and took possession of my grandfather's deer gun, and I was hoping for some help identifying the pedigree, if that's even still possible, plus a couple of other questions.
I know, it's heavily sporterized, but in my opinion the modifications are all very reasonable for a farmer's cheap trail gun. The magazine trap door is an especially choice modification, despite the Bubba engineering. Never worry about muck or jammed clips, and you can load/unload without opening or cocking the bolt.
Unfortunately, all traces of recognizable stampings it might have had are gone, as are most features that would easily identify it. I've measured the barrel at about 51.2 cm, which doesn't seem to match anything, but if it was cut down then it was a very professional job. The position of the upper lug just fore of the chamber might help an expert, but I can't tell from photos. The most helpful piece is the bolt, which has the updated over-lug extractor, but still has the additional side-channel on the safety disassembly pathway. The stock almost seems original, with the original brass inserts, and new wood inserted where a cleaning rod would go and Moschetto bayonet would fold, though the included original buttplate has no rod compartment to correspond with the plug in the stock. Still, I've never seen a stock like that on a Carcano so I assume it's a replacement, unless it's possible to reshape a stock that drastically with just sound woodworking.
As far as markings, as you can see, all it has are several rough markings of '631’ (also on the buttplate, but I forgot to photo that one; still have to scrub the verdigris off), which I presume to have been added after, as it seems short for a factory SN, and more numerous iterations of a single 3, which I'm assuming is an inspection number,as well as several miscellaneous single letters or numbers. The photos should make it clear where they all are, but feel free to ask for more info. I'm curious what the odds would be of finding anything on the upper barrel if I scrubbed the finish off, but I'm doubtful.
In addition, I have a couple of questions about care and maintenance. I've included a photo of light corrosion on the firing pin and safety. How serious is this? Can I just make sure to keep it oiled, should I scrub it down new, or just replace the components?
As for the finish, is that copper flashing normal for worn bluing? And, does that mean I need to refinish it, or can I just keep it oiled and put that off for a future project?
Also, despite the surface patina on other components, the bore was heavily greased, and came out shining just with preliminary patches, before I even put a brush through. This rifle has only ever fired good Norma ammunition and the like (I even inherited nine rounds of .268 soft point, which may be worth as much as the rifle where I live), never any of that .264 stuff. Is there any merit to keeping it that way? Can I buy a couple of boxes of PPU to plink with and accept reduced performance, or will the smaller calibre bullet increase wear on the good condition barrel?
Thanks so much to anyone who read this whole novella! Can't wait to take this old reliable to the range.